TEEM MODULE N° 26E1075203B UHF TRANSMITTER No UHF Antenna UHF Data link option introduction The UHF data link allows operations in the UHF DESIGNS, the KART or the LRK® formal. The UHF data link comes as a hardware option, unless you have an Aquarius 500x xK or Aquarius 500x xD receiver, in which case the UHF data link is part of your purchase.
Installation: o UHF transmitter Installed at the reference station, it is simply plugged onto the Sub D 15-C connector located on the rear panel of your receiver (Port D, R422, GPS. The ULF transmitter is scoured on the rear panel by four SCIATIC. « UHF receiver Only skilled people can perform this operation as it requires to open the receiver case. « UHF ante A PRO COM (P4503 whip antenna is used both at the reference station and at the mobile The accessory kit consist coaxial cable (6.5m long for the.
I Frequency modification. SGPMSK, Comment: 458550.0 is the desired frequency in KHz. 2. Frequency request. Comment: when the unit receives this command and if the communication parameters are correct, it'll send back the programmed frequency. 3 Power ON (CW. mode). SPDAS,TEST,8,5 , Comment: the transmitter will broadcast 2 non-modulated signal, 4._ Frequency center {re-center the transmission in CW mode only).
Transmitter Sub-D 15¢ Device Under test Receiver module Casanovas f—r — Sub-D 15¢ PC File : OUTDREW Command List with UFH Transmitter or UHF Receiver (with TRS.EXE program DOS). VER 2 FREQ=> POSTGRESQL Modulation type. DEFAULT =» RESET <> CONFER SPAT > Rec All stations 511 ON = TEST OFF>> CON > COEFFICIENT CWS ON NIVEA DAT ON PRESIDENTIAL . $GPCRQ,MSKJ $PDAS,DEFLT PRESETTING) SLAPDASH, TABLE $PDAS,PSAT, 1] $PDAS,NSTRCK,00. $PDAS,TEST,8,6. $PDAS,TEST,8,0.) SLAPDASH, TEST 8,5.