User's Manual

MobileMapper 50 Quick Start Guide
Product Name
Model Name
LCD DISPLAY
UNIT SIZE
WEIGHT
BATTERY
FRONT CAM
BACK CAM
Operating temperature
operating voltage
Specification
Unpacking
• MobileMapper 50 unit • USB cable
• International battery charger • Two spare screen protection films
This package does not include the headset for device
Front and Rear Views
Installing Card (SD)
Rugged Smart Phone
MobileMapper50_WiFi
5.3 1280X720 BRIGHTNESS 400
164x82x14.6
278g
3100mAh
2M
8MP，FLASH Software Set
-20°C – 60°C
3.5V-4.2V
Front Camera Lens *
+
Volume
Lanyard Eye
Power Button
External GNSS Antenna Input
Speaker
Rear Camera Lens
Power/Data Connector **
Battery Trapdoor Lever
This recess to eject the battery trapdoor
Battery Trapdoor
Reset button
Micro USB
-
Headphone
Function Key 1
Function Key 2
Touch Screen
Menu
Return
Home
+
-
*: Depending on model ** :Not used
Charging the Battery before First Use
Use the USB cable provided: Connect the small end to the device’s Micro USB connector, and the other end either to a USB connector on
your computer, or to the battery charger. In the latter case, connect the charger to a power outlet after choosing the adapter that is suitable in
the country of use. Then whatever the charging source used, wait until the screen reports a fully charged battery.
Turning on MobileMapper 50. Hold the power button depressed until the splash screen appears.
Using MobileMapper 50. Refer to the documentation of the Android application you wish to use so you can safely install and run this
application.
Entering/Quitting the Sleep Mode. When active, this mode allows you to save battery power while keeping the unit running in the
background. To enter the sleep mode, just press the Power button briefly. To return to normal operating mode, press this button again.
Turning Off MobileMapper 50. Hold the power button depressed until the shutdown message is displayed. Select Shutdown and touch OK.
CAUTION: This product contains a rechargeable Li-ion battery. Please refer to the regulations in force in your country concerning
the use and transportation of Li-ion batteries.
P/N 631676
© 2016 Trimble Navigation Limited. All rights reserved. Spectra Precision is a Division of Trimble Navigation Limited. Spectra
Precision and the Spectra Precision logo are trademarks of Trimble Navigation Limited or its subsidiaries. This product is
protected by US and international copyright, trademark and patent law. Revision A.
www.spectraprecision.com
Install the card BEFORE inserting the battery: Slide the battery trapdoor lever downward. Then use a flat,
rigid plastic strip that you insert into the recess (see picture) to eject the battery trapdoor. Orient the cards as
illustrated, contact side facing down, before pushing them in.
Inserting the Battery. Insert the battery gently into the compartment, making sure the electrical contacts of
the battery are pushed against those located in the battery compartment. Put the trapdoor back in place:
First insert its two legs into the lower part of the unit, then push the trapdoor against the unit, gradually from
bottom to top, using your two thumbs, until you reach the top of the trapdoor. Then slide the lever upward
with a thumb.