User's Manual

ManualsBrandsTriMark ManualsElectronics38477-01

0



TriMarkCorporation

Generation3EAskSystem

FCCgeneralinformationdoc

Contents

37843‐IOModule.........................................................................................................................................2

PinLayout..................................................................................................................................................2

J11 – Baseboard 12-pin.........................................................................................................................2

J13 – Baseboard 14-pin........................................................................................................................2

J1 – Programmable Inputs & Relay Outputs Group 1......................................................................2

J2 – Key Switch & Relay Outputs Group 2........................................................................................3

J3 – External Relay Drivers.................................................................................................................3

J4 – Relay Outputs Group 3................................................................................................................4

J5 – Relay Outputs 4............................................................................................................................4

J14 - JTAG Connector..........................................................................................................................4

GeneralSpecifications...............................................................................................................................4

IOModuleFCCversion..............................................................................................................................6

Wiringdiagram..........................................................................................................................................7

FCCruleandregulation.............................................................................................................................8



ThisdevicecomplieswithPart15oftheFCCRules.Operationis subjecttothefollowing two

conditions:

(1) This device may not cause harmful interference, and (2) This device must accept any

interferencereceived,includinginterferencethatmaycauseundesiredoperation.



Lemanueld'utilisationdesappareilsradioexemptsdelicencedoitcontenirl'énoncéquisuit,ou

l'équivalent,àunendroitbienenvueet/ousurlesappareils:



Summary of content (10 pages)

PAGE 1
TriMark Corporation Generation 3 EAsk System FCC general information doc Contents 37843‐ IO Module ......................................................................................................................................... 2 Pin Layout.................................................................................................................................................. 2 J11 – Baseboard 12-pin...........................................................................................
PAGE 2
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
PAGE 3
7843‐ IO Module Pin Layout J11 – Baseboard 12-pin Error! Objects cannot be created from editing field codes. Pin Signal Name J11.1 J11.2 J11.3 J11.4 J11.5 J11.6 J11.7 J11.8 J11.9 J11.10 J11.11 J11.12 VIN PROG_IN_3 PROG_OUT_2 PROG_OUT_1 PROG_IN_1 LF_ANT125_OUT_1 RELAY_20A_1 RELAY_20A_2 CANL CANH GND LF_ANT125_IN_1 Input/ Output Input Input (+) Output Output Input (+) Output Output Output In/Out In/Out Input J13 – Baseboard 14-pin Error! Objects cannot be created from editing field codes.
PAGE 4
J1.2 J1.3 J1.4 & 16 J1.5 & 17 J1.6 & 18 J1.7 & 19 J1.8 J1.9 J1.10 J1.11 J1.12 J1.13 J1.14 J1.15 J1.20 J1.21 J1.22 J1.23 J1.
PAGE 5
J4 – Relay Outputs Group 3 Error! Objects cannot be created from editing field codes. Pin Signal Name J4.1 J4.2 J4.3 J4.4 J4.5 J4.6 RELAY_20A_102 RELAY_20A_101 RELAY_20A_104 RELAY_20A_103 RELAY_20A_105 RELAY_20A_106 Input/ Output Output Output Output Output Output Output J5 – Relay Outputs 4 Error! Objects cannot be created from editing field codes. Pin Signal Name J5.1 J5.2 J5.3 J5.
PAGE 6
PROG_IN_101 PROG_IN_102 PROG_IN_103 PROG_IN_104 PROG_IN_105 PROG_IN_106 PROG_IN_108 PROG_IN_109 KEY_SWITCH_1 KEY_SWITCH_2 PROG_IN_2 & PROG_IN_3 PROG_OUT_101 activates while PROG_IN_101 is active. PROG_OUT_102 activates while PROG_IN_102 is active. RELAY_20A_105 activates while PROG_IN_103 is active. RELAY_20A_106 activates while PROG_IN_104 is active. PROG_OUT_105 activates while PROG_IN_105 is active. PROG_OUT_106 activates while PROG_IN_106 is active. RELAY_20A_101 activates while PROG_IN_108 is active.
PAGE 7
Operating Principals: Operating Principle of Wi‐Fi/Bluetooth: TriMark believes we will use this for information transfer such as communication on a smart phone. This is a future proofing accessory. Wi-Fi/Bluetooth with modular certificate , FCC ID:XF6-RS9113SB IC:8407A-RS9113SB IO Module FCC version LF will constantly generate a 125 KHz wave on channel 1 as long as it is plugged in. Do not leave on more than 4 hours at a time. Channels 2 and 3 use the same circuit, but will not be on.
PAGE 8
Wiring diagram All other IO are not populated.
PAGE 9
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 10
This device complies with part 15 of the FCC Rules and Canada licence‐exempt RSS‐210 standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.