e-ASK Electronic Access Security Keyless-entry e-FOB RF Keyless-entry System Instructions FCC ID: TV2EFOB1
Table of Contents Introduction .............................................................................................1 e-FOB Operation and Features ..............................................................2 Teaching Additional Fob Transmitters .................................................3 Smart Led: ............................................................................................4 Dip Switch Setting Assignment .............................................................
Introduction e-FOB Operation and Features This manual provides the necessary information for the installation and use of TriMark’s e-FOB transmitter/receiver system.
Smart Led: Teaching Additional Fob Transmitters The smart LED indicates system status: • Slow Flash = Armed • Off = Disarmed • Fast Flash = Alarm activated Dip Switch Setting Assignment The DIP Switch settings control additional functions. Power to the receiver should be disconnected and reconnected after a DIP switch is changed. Functional assignments are described below: Switch 1. Plug the LED into C6 and the push button into C7 on the receiver. 2. Turn ignition off and unlock doors. 3.
DIP Switch #1: Horn/Panic Mode • • DIP Switch #7: Automatic Lock/Unlock • DIP switch #1 ON: the Horn button (center left) provides a pulse output. DIP switch #1 OFF: the Horn button (center left) actuates panic mode. • DIP Switch #2: Sustained Output • • DIP switch #2 ON: the middle left and right buttons provide sustained outputs. Output lasts as long as the button is pressed– up to 30 seconds. Middle left button activates horn output. Middle right button activates auxiliary output.
Appendix: Installation and Mounting e-FOB System WIRE COLORS Contact TriMark for specific mounting details, such as drawings, placement suggestions, mounting hardware, etc. General Mounting Guidelines: CONNECTOR 1: 4-PIN HARNESS -- -- 1 Yellow Ignition Input 2 Black Ground Input 3 Red Power (+12V) 4 WIRE COLORS The RF receiver should be placed in an interior location that does not shield RF signals. You may need to try multiple locations to optimize reception.
WIRE COLORS Wiring Connections for Basic System Functions CONNECTOR 5: 10-PIN HARNESS Green/Black Door Lock (N/C) (relay 30A) 1 -- -- 2 Purple Dome Light Output (relay 15A) 3 Pink Dome Light (N/O) (relay 15A) 4 Pink/Black Dome Light (N/C) (relay 15A) 5 Green/White Door Lock (N/O) (relay 30A) 6 Green Lock Output (relay 30A) 7 Blue/Black Door Unlock (N/C) (relay 30A) 8 Blue/White Door Unlock (N/O) (relay 30A) 9 Blue Unlock Output (relay 30A) 10 * DO NOT USE A TEST LIGHT ON THE