User Manual

SECUREMESH 1 WATT RADIO MODULE

INSTALLATION INSTRUCTIONS

May30,2009



TheTrilliant1WattSe cureMeshRadioModuleisa2.4GHz802.15.4transceiverradiomoduleintended

foruseinelectricmeters,gasmeters,andnetworkproductandinhomeproductsforutility

applications.Themodulecontainscastellationsforconnectionstoexternalantennaboard,suchasthe

1.1dBi

“L”shapedantenna.ThemodulealsoallowsdirectconnectionforanoptionalU.FLconnector.

Powerissuppliedbyahostmodulewithanominalvoltageof3.3volts.



Specificationoftheradiomodule:

 IEEEstandard:  802.15.4

 PowerOutput : +30dBm

 RadioSensitivity: ‐99dBm

 RFDataRate:  250

kbps

 OperatingFrequency: 2.400‐2.483GHz

 NetworkTopology: Mesh

 Modulation:  O‐QPSK

 PhysicalDimensions: 1.400”x2.075”

 AntennaOptions: CastellationtoExternalBoard,U.FL





Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one of

the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

FCC Caution

: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

PAGE 1
SECUREMESH 1 WATT RADIO MODULE INSTALLATION INSTRUCTIONS May 30, 2009 The Trilliant 1 Watt SecureMesh Radio Module is a 2.4GHz 802.15.4 transceiver radio module intended for use in electric meters, gas meters, and network product and in home products for utility applications. The module contains castellations for connections to external antenna board, such as the 1.1 dBi “L” shaped antenna. The module also allows direct connection for an optional U.FL connector.
PAGE 2
INDUSTRY CANADA STATEMENTS Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.
PAGE 3
or “Contains FCC ID: TMB-EM0069 “Contains IC: 6028A-EM0069 The Trilliant SecureMesh 1 Watt Radio Module must only use the approved antenna(s) listed above, which have been certified with this module. Trilliant will not provide information to the end user regarding how to install or remove this RF module or change RF related parameters in the user manual of the end product. The module will be professionally installed inside a meter.