Instructions / Assembly

PRODUCT WARRANTY
The product warranty is one year (hereafter referred to as “Product Warranty”).
TrickleStar warrants to the original purchaser that, for the Product Warranty, it shall be free of defects in design, assembly, material, or
workmanship and will repair or replace, at its option, any defective Product free of charge.
In no event, shall TrickleStar be liable for incidental, special, direct, indirect, consequential, or multiple damages such as, but not limited
to, loss of business or profits arising out of the sale or use of the Product, even if advised of the possibility of such damages. This warranty
gives the original purchaser specific legal rights which vary from state to state. Some states do not allow the exclusion or limitation of
incidental or consequential damage, so the above limitations may not apply to you.
This warranty is valid only for the original purchaser of the Product. All damage claims against the Product must be made within 30 days
from the date of the occurrence and must be accompanied by a receipt for the damaged devices, or the warranty is void.
This warranty is valid in USA and Canada.
MAKING A CONNECTED WARRANTY CLAIM
Go to: www.tricklestar.com and print our Connected Warranty Claim form and email it to [e-mail].
Provide the following information:
• Product model number
• The date of the occurrence
• Where you purchased the Product
• When you purchased the Product
• A copy of the original receipt
A customer service representative will then instruct you on how to forward your Product, purchase receipt, a photograph of the Product in
use at the time of the occurrence, and information on how to proceed with your claim.
COPYRIGHT & DISCLAIMER
Copyright © 2018 TrickleStar PAGE 1Copyright © 2018 TrickleStar Rev 11 : 28 June 2018PAGE 4
PRODUCT INFORMATION
TS1910 USB Motion Sensor
(12 inches, 300mm)
USB Motion Sensor
Bracket
USB Extension
Cable 3.28 ft. (1 m)
Sleep Mode Quick Activation Button
& Timer Configuration
© Copyright TrickleStar Inc. All rights reserved. TrickleStar®
is a registered trademark of TrickleStar Ltd. Any
typographical, clerical or other error or omission in this
document or other documents or information issued by
TrickleStar shall be subject to correction without any liability on
the part of TrickleStar without notice.
The USB Motion Sensor is compatible with the following:
Windows
7
Windows 8.1
Windows 10 (Anniversary Update)
Windows 10 (Creators Update)
Mac OS10.12 “Sierra”
Mac OS
10.11 “El Capitan”
Linux Mint (Debian based)
Linux Centos 7 (Redhat Enterprise Linux)
FOR TECHNICAL SUPPORT
Toll free : 1-888-700-1098
www.tricklestar.com
INTRODUCTION
The USB Motion Sensor is a patent-pending, motion
sensor system powered by the computer via a USB cord and
which places the computer into sleep mode if no motion is
detected for a period of time. This allows you to quickly and
inexpensively set up a control solution for your computer,
requiring no special software or additional programming.
USB MOTION SENSOR - OPERATION
Sensor
Initialization
Default Timer
(Sleep mode)
Countdown Timer
(Sleep mode)
Countdown Timer
Expiration
(Sleep mode)
The USB Motion Sensor takes up 3 seconds to initialize after being connected to the computer.
The blue LED will illuminate during initialization.
The configurable countdown timer is set to 15 minutes (default) and can be adjusted (+/- 5 minutes).
The countdown timer will begin counting down once motion is detected for the first time.
The countdown timer is reset each time motion is detected.
The sleep command will be initiated upon expiration of the countdown timer.