Instructions / Assembly
Align side panels at right angle (90 degrees) with the receiving panel
elevated 4 inches.
Interlock tongues and grooves then push panel down to lock.
Repeat step 1 to form 3 sided box
Install top panel with arrow toward open end of box. Align locking tabs and
snap into place using palm of hand or rubber mallet.
( Top panel can also be rotated for le or right louver exhaust).
*Recommend not exhausng toward house if possible.
1 TOP PANEL * 3 SIDE PANELS
4 STAKES BRANCH QTY
36A Unit = 372
4 BUNGEES 46A Unit = 824
56A Unit= 1488
Pre-shape branches and install into branch holes to 1 inch
depth. Push branch stem straight into holes
DO NOT TWIST.
Then reshape branches to natural “full” appearance
Aer placing TRiCC ulity cover in final posion over equipment,
aach bungee to stake (as pictured) so that when stake is driven into
the ground at each of the corner locaons, the bungee can stretch
over the hook located on panel and be secured. If unit is on exisng
pad, drill 3/8” hole and drive stake into hole in pad.
Copyright Real Life Products, LLC 2011 all rights reserved
Panel corner detail
Contents
www.triccover.com
Bungee/Stake
assembly
Note: For permanent branch installaon,
customer may apply small drop of sili-
cone adhesive to each hole prior to
installing branch (silicone sold separately)
INSTRUCTION SHEET
*No Tongues
Instructions for: 36A, 46A and 56A TRiCC®utility cover
*See air collar
install instructions