Installation Instructions

This quick guide demonstrates how to set up and install the Bluetooth Wireless Car Kit into a vehicle. For

more detailed information about the use and functions of this device, refer to the user’s manual.

Identifying Components

Unpack the Car Kit package and check it contains the following components.

• One junction box

• One control module

• One multi-directional microphone

• One speaker with mounting bracket

• One set of power cables

If any items are missing or damaged, contact your dealer.

A. Installing the Junction Box

The Car Kit is designed to work with the 12-volt power supply of the vehicle. Refer to the following to install

the junction box in a vehicle.

1. Locate a suitable place inside the car to mount the junction box. Select a dry place that avoids

excessive heat and mechanical vibration. Ideally, the junction box should be hidden from view,

but still easily accessible.

Note: Make sure that the cables are long enough to support the location of the junction box. If

the cables are not long enough, do not lengthen the cables; relocate the junction box.

2. Use two screws (not included) to fasten the junction box in place.

B. Connecting the Power Supply

The following illustration demonstrates how to connect the Car Kit’s power cables to the vehicle’s

electrical system.

GND

Power cables

To car radio

mute (PNP 300mA)

Yellow cable

To battery + 12V

Red cable

To ignition

Blue cable

Black cable

PAGE 1
This quick guide demonstrates how to set up and install the Bluetooth Wireless Car Kit into a vehicle. For more detailed information about the use and functions of this device, refer to the user’s manual. Identifying Components Unpack the Car Kit package and check it contains the following components. • • • • • One junction box One control module One multi-directional microphone One speaker with mounting bracket One set of power cables If any items are missing or damaged, contact your dealer. A.
PAGE 2
Important! The Blue cable must be connected to the 12V switched to enable the Car Kit to go into standby mode. Do not connect the Blue cable to the +12V permanent. Doing so may discharge the battery of the vehicle and prevent the Car Kit from being reset. C. Connecting Accessories The following illustration shows where to connect accessory devices. Junction box Control module Microphone Speaker D. Control module The control module should be located within reach and view of the driver.
PAGE 3
2. Remove the other protective cover, and firmly press the stand in place. 3. Push the microphone into the stand. Using the microphone visor clip 1. Slide the visor clip onto the visor with the microphone clip facing down. 2. Push the microphone into the mounting clip. Upgrading Firmware (optional) It may be possible to use future phone models by upgrading the firmware in the Car Kit. Firmware is upgraded via the serial port located on the back of the junction box.