UNIT WEIGHT: 18in (10 lbs) 24in (12lbs) 30in (16 lbs) WEIGHT CAPACITY PER SHELF/TIER: 10 LB JUNEAU INDUSTRIAL WALL MOUNTED ETAGERE RACK
Each New Age furniture design utilizes a simple & effective fastening system to quickly assemble your unit. To reduce assembly time, each fitting (connector) has pre-installed set screws (spare set screws are provided) at EACH pipe entry location. Set screws are tightened using a 1/8” Allen Key, which safely secures the pipe in place.
10.00" 18", 24", or 30" 10.77" 12.00" 12.00" 10.19" 38.81" 0.81" 15.00" VARIES* 13.4", 19.4", 25.
[x1] Bottom Crossmember Assembly [x3] Shelf 2 1 [x2] Shelf Support Assembly [x1] Left Top Shelf Support Assembly 4 3 [x1] Right Top Shelf Support Assembly 5 [x1] 1/4" Allen Key Large Key [x1] 1/8" Allen Key Small Key [x4] Ø8mm X 40mm Screws 6 7 8 [x4] Plastic Wall Anchors 9 NOTE: SMALL ADJUSTMENTS MAY BE NEEDED ON SUBASSEMBLIES DUE TO SHIPPING MOVEMENT 5
1 1 3 2 USE PART 6 TO TIGHTEN ALL NEW CONNECTIONS [x2] 2 1 3 USE PART 6 TO TIGHTEN ALL NEW CONNECTIONS [x2] FROM STEP 1 MAKE SURE TO TIGHTEN ALL AREAS! Note: For Ease of Assembly, assemble laying down as shown. Protect floor from being scratched by pipe. Pictures are for reference.
3 4 5 FROM STEP 2 USE PART 6 TO TIGHTEN ALL NEW CONNECTIONS [x2] WARNING: FAILURE TO SECURE UNIT TO WALL AS SHOWN MAY RESULT IN SERIOUS INJURY 7
4 1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL LINING AT LEAST ONE SIDE UP WITH A STUD. 2. LIGHTLY MARK YOUR WALL USING A PENCIL IN EACH MOUNTING HOLE ON THE FLANGES. 3 3. REMOVE UNIT FROM WALL AND PREDRILL YOUR MARKED SPOTS USING A " DRILL BIT. 16 5 IF NOT GOING DIRECTLY INTO STUD, USE ANCHOR (ITEM 9). DRILL " HOLE AND HAMMER 16 ANCHOR INTO PLACE. 4. PLACE UNIT BACK ON WALL AND INSERT SCREWS (ITEM 8) INTO FLANGES & TIGHTEN USING ITEM 7. DO NOT OVER TORQUE.