Installation & Assembly

VANITY LIGHT

TOOLS REQUIRED

CAUTION

Assembly Instructions

Wire

strippers

Ladder

Safety

glasses

Electrical

tape

Phillips

screwdriver

PliersFlat blade

screwdriver

• Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect in

the wire, do not attempt installation.

• Before starting installation of this ﬁxture or

removal of a previous ﬁxture, disconnect the

power by turning o the circuit breaker or by

removing the fuse at the fuse box.

Fixture

Socket Ring

Cage Screws

page 1

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

Mounting Screws Wire Nuts

Cap Nuts

Mounting Unit

PAGE 1
VANITY LIGHT Assembly Instructions CAUTION • Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. • Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
VANITY LIGHT Assembly Instructions STEP 1 Use the mounting screws to attach the mounting unit to the junction box STEP 2 Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts.