D E 8pcs 8pcs
Insert Cam Bolts (B) into pre-drilled holes of parts 1,3,4,6,7 using a Phillips head screw driver as shown. Do not over tighten. Attach Handle Washers (H) and Handles (G) to Doors (15 &16) using Short Hex Socket Head Bolts (E) and Allen Key (F) . Attach Magnets (K) to Front Rail (11) using Round Head Screws (L) as shown. Insert Right Wine Holder Shelf (14) to Left Holder Shelf (13) as shown.
Attach Handle Washers (H) and Handles (G) to Drawer Front Panel (17) using Short Hex Socket Head Bolts (E) and Allen Key (F) . Attach Drawer Back Panel (20) to Drawer Side Panels (18 &19) using Short Flat Head Screws (I). NOTE:be sure that drawer slide joint are facing outward . Slide Drawer Bottom Panel (21) into grooves of Drawer Side Panels (18 &19) . Attach Drawer Front Panel (17) to Drawer Side Panels (18 &19) using Short Flat Head Screws (I). Repeat for second drawer .
Attach Front Rail (11) and Back Rail (12) to assembled parts( 6,7& 8 ) using Wood Dowels (C) Long Hex Socket Head Bolts (D) and Allen Key (F) as shown. 7 Attach Upper Partition Panel (5) to Rails (11&12) using Wood Dowels (C) and Long Flat Head Screws (J) as shown.
Turn assembled parts ( 6,7,8,11&12) with the side face down.Attach Bottom Panel (2) using Wood Dowels (C) . Attach Center Support Legs (24) by turning clockwise into the pre-drilled holes as shown. Note: The adjustable leveler on the bottom of the Center Support Legs (24) should not be extended until after installation .Adjust the leveler on the bottom of the Center Support Legs (24) until it fits tightly against the floor .Use of the support leg is important to support the center of the cabinet .
Carefully turn cabinet over.Attach Top Panel (1) using Wood Dowels (C), Cam Locks (A), Long Flat Head Bolts (D) and Allen Key (F) as shown. F Attach Doors (15 &16) to cabinet by placing bottom Pin Hinge into pre-drilled holes in Base (2) & depressing top spring loaded pin hinge to fit the door into place in Rail (11) . Note-Be sure Pin Hinges (top &bottom) have fully extended into the pre-drilled holes in Base (2) and Rail (11) to secure doors into place .
Attach Back Panels (22&23) to cabinet using Round Head Screws (L) as shown. L L L L L L L L L L L L L L 22 L L 23 L L 22 L L L L L L L L Insert drawers into cabinet as shown. Left drawer has a brand in it .
Insert assembled wine holder shelf into cabinet as shown. Insert the Shelf Holders (M) into desired position. Insert Adjustable shelf (9&10) into cabinet.
N A B C D 8*3/4" SAFETY STRAP KIT 1PC WALL ANCHOR A x 1PC WASHER B x 2PCS SHORT SCREW C x 1PC D E D 8*1-1/2" LONG SCREW SAFETY WALL STRAP D x 1PC E x 1PC SAFETY WALL STRAP ASSEMBLY INSTRUCTION 1)Insert Short Screw Part (C) through Washer Part (B) and Safety Wall Strap Part (E) and screw it into Top Panel (1). 2)Drill a 11/32" hole where you want to secure your pantry .The hole should be at the same height as the hole in Top Panel (1). Tap Wall Anchor Part (A) into the hole .