TEW-T1 2.4 GHz Wi-Fi Detector User’s Guide Guide de l'utilisateur détecteur Wi-Fi 2.4 Ghz 2,4 GHz WiFi-Detektor Diese Benutzeranleitung Esta guía del usuari Detector 2.4 GHz Wi-Fi Version 11.30.04 TRENDnet TRENDware, USA What's Next in Networking Copyright ©2004. All Rights Reserved. TRENDware International, Inc.
Table of Contents English ...................................................................................................... 1. Prepare for Installation ...................................................................... 2. Product Detail ..................................................................................... 3. Hardware Installation ........................................................................ 4. Using TEW-T1 ..................................................................
English UG 1. Prepare for Installation Thank you for purchasing the TRENDnet TEW-T1 2.4 GHz Wi-Fi Detector. This guide will help you set up your 2.4 GHz Wi-Fi Detector. Following the installations should be quick and easy. If you run into problems, please refer to the Troubleshooting section. If you need further technical support, please visit www.TRENDNET.com or call technical support by phone. Verify Package Contents Please make sure you have everything in the box: TEW-T1 2.
2. Product Detail The 2.4 GHz Wi-Fi Detector has buttons to activate signal detection and LEDs to indicate the strength and type of signal.
3. Hardware Installation 1. Slide the battery door towards the arrow's direction. 2. Insert 2 AAA batteries inside the battery chamber, having the negative pole pressed against the springs. Positive Negative 3. Slide the door back into the battery chamber. Your hardware installation is now complete.
4. Using TEW-T1 1. Holding the Tester Hold the tester from the sides and point the back of the tester in the direction you wish to scan. When you hold the tester, make sure that you don't block the antenna. 2. How To Find Wi-Fi Signals Press either the Auto or Manual button to detect a Wi-Fi signal. The LEDs will display the Wi-Fi signal and strength. Move in the direction of the strongest signal to pin down the signal source or best Wi-Fi hotspots. 3.
Troubleshooting Q1: I have inserted 2 AAA batteries in the TEW-T1, but nothing comes on when I press any of the buttons. What do I do? A1: Be sure that you have inserted the batteries properly (See 3. Hardware Installation). If you have inserted the batteries properly, remove the batteries and insert new batteries. Q2: Can rechargeable AAA batteries be used for Wi-Fi detector? A2: No. The Wi-Fi detector can only be used by non-rechargeable batteries.
TRENDnet TRENDware, USA What's Next in Networking @ Product Warranty Registration Please take a moment to register your product online. Go to TRENDware’s website at http://www.TRENDNET.com TRENDware International, Inc. 3135 Kashiwa Street Torrance, CA 90505 http://www.TRENDNET.com Copyright ©2004. All Rights Reserved. TRENDware International, Inc.