Wiring Diagram

ManualsBrandsTRAVELLER X ManualsElectronicsTRV X WIRELESS REMOTE

WSE8+WSR3 Remote Controller

Instructions

Contents：

1. Function and characteristics

2. Main technical parameters

3. Working principle and wiring diagram

4. Using method and Precautions

5. Maintenance and repair

1. Function and characteristics

1.1 Function

The wireless remote controller is mainly used to replace manual switch for

operating winch from a certain distance.

1.2 Characteristics

The remote controller easy to use, low power and automatic keep shut down,

stable performance anti-interference ability and so on.

2. Technical parameters

2.1 Transmitter power: Powered by two 1.5V 1600mah AAA batteries

2.2 Operating Voltage：12V-36V

2.3 Remote control distance：0-40m

2.4 Remote control angle：0-360°

2.5 Operation delay：≤20ms

2.6 Number of coding groups: ≥ 10 million groups

2.7 Waterproof grade IP67

Normal operating conditions；

Temperature environment：—40 ∽ +45℃

Relative humidity：≤95%RH（25℃）

Summary of content (4 pages)

PAGE 1
WSE8+WSR3 Remote Controller Instructions Contents： 1. Function and characteristics 2. Main technical parameters 3. Working principle and wiring diagram 4. Using method and Precautions 5. Maintenance and repair 1. Function and characteristics 1.1 Function The wireless remote controller is mainly used to replace manual switch for operating winch from a certain distance. 1.
PAGE 2
3. Working principle and wiring diagram 3.1 The remote control uses 433.92MHZ wireless transmission technology and sends instructions to the receiver to control the winch. 3.2 wiring diagram If the direction of the winch reverses, exchange the white and yellow lines connection. 4. Using method and Precautions 4.
PAGE 3
4.2Precautions：（1）The maximum operating voltage is 36V. Please use a reasonable choice of power；（2）When installing and adjusting the winch especially when finishing the wire rope, make sure that the transmitter is power off; （3）The transmitter and receiver of the remote control are paired and can't be interchanged unless the code is consistent; （4）If you do not use the remote control for a long time, remove the battery and replace the battery regularly. 5. Maintenance and repair 5.
PAGE 4
Warning Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.