WF7916 WiFi Module Date: 2019/11/1 WF7916 WiFi module specification Preliminary data subjects to change without notice 1
WF7916 WiFi Module Date: 2019/11/1 A. Features IEEE 802.11 b/g/n compliant 1T1R mode with support of 150Mbps PHY rate Integrated LNA, PA and T/R switch Support with USB 2.0 high speed mode Embedded 32-bit RISC microprocessor Integrated EFUSE to eliminate the requirement of external EEPROM Outline: 15.24x 17.27 x 3.22 mm B.
WF7916 WiFi Module Date: 2019/11/1 C: Specification Parameter Min. Typ. Max. Unit 3 3.3 3.6 V Electrical Section Supply Voltage Crystal 40M Hz Transmitter Section 802.11b (CCK) 11Mbps 18 dBm 802.11g (OFDM) 54Mbps 16 dBm 802.11n (HT20) @MCS7 15 dBm 802.11n (HT40) @MCS7 15 dBm 802.11b (CCK) 11Mbps -85 dBm 802.11g (OFDM) 54Mbps -70 dBm 802.11n (HT20) @MCS7 -69 dBm 802.
WF7916 WiFi Module Date: 2019/11/1 E: Pin Assignment and Dimension: Preliminary data subjects to change without notice 4
WF7916 WiFi Module Date: 2019/11/1 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
WF7916 WiFi Module Date: 2019/11/1 This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. 3) Module approval valid only when the module is installed in the tested host or compatible series of host As long as 3 conditions above are met, further transmitter test will not be required.
