User's Manual

2
Less than 50cm
1
2. Name : Sensor Name
3. : Search this sensor. If searched, the sensor LED will flash five times.
4. Alarm On/Off : “Alarm On ” will enable you to receive push message when
PIR sensor event is triggered. The interval between checks is 1 minute.
5. : The camera will rotate to a preset position when “Alarm On”
and PIR sensor event is triggered. Through live view window to position
the camera and tap “Locate” to confirm.
1. No. : Sensor Number. Tap it to select other sensor. (No. 0,1,2….)
Sensor Setting
3
1
2
4
3
5
1
1
Step1: Battery On
1. Remove the back cover.
2. Install three AAA batteries.
Step2: Sensor Pairing
1. Turn on camera and launch “iSmart-CAM” APP. Go to “Camera Setting”
and tap ”IoT Sensor Setting”.
2. Tap the then hold the pairing button for 3 seconds
within 5 seconds.
3. The sensor type will be displayed after paring completed.
4. Tap the “RIR Sensor” for detailed settings.
Note: If pairing successfully, the LED will light up for 3 seconds.
If failed, the LED will blink.
EN
Pairing Button
2. LED Light
3. PIR Sensor
1.
Product Layout
1
Quick Setup
2
1
2
3
RF_PIR
RF_PIR Sensor
Installation Guide
Manuel de l'utilisateur
Guía de instalación
Installationsanleitung
Guida all'installazione
3
1
Placement
4
1
- Modulation: GFSK
- Dimensions: 64x44x24 mm
- Weight: 21.5 g
- Detect Distance: 3~5m
- Coverage Angle: 110°
- Operating Distance: 30m* (indoor)
- Power Supply: 4.5V (AAAx3)
- Battery Life: 1 year* (Triggered twenty times a day)
- Operating Temperature:
*Actual operating distance and battery life may vary with the usage
patterns and operating environment.
- Frequency: 2.4G Hz
RF
0℃ ~ 40℃ (32℉ ~ 104℉)
Specification
5
2 m (Approx.)
Note: 1. Avoid facing to glass
windows/doors.
2. Avoid facing to
heat/cold sources.
3. Avoid facing swing
objects.
410-000090-00
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20
cm must be maintained between the antenna of this device and all persons.
This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.