User's Manual

Installation Manual of 700MHz UHF

Transceiver

P07-1111-2-24

Nov. 2003

PAGE 1
Installation Manual of 700MHz Transceiver P07-1111-2-24 Nov.
PAGE 2
Transystem, Inc. www.transystem.com.tw 1. Before you unpack the box, please check if there are one P071111-2-24 transceiver and one mounting bracket inside. 2. To install the transceiver onto a mast, you will need: a. An indoor power inserter/adapter (provided by TSI) b. A 75 ohm coaxial cable (RG 6, RG 7 or RG 11) to run up the mast to the transceiver c. A 75 ohm UHF Yagi antenna of proper gain d. A short 75 ohm (RG-59, RG 6, RG7 or RG 11) coaxial cable to connect the transceiver with the antenna 3.
PAGE 3
Fig. 1: Installation of transceiver with UHF Yagi antenna NOTE: Cable modem “Channel Size” settings must be configured so that channel center frequencies at band edge will meet the limits in the following table: Data rate kSym/sec 320 640 1280 Lowest fc QAM 710.4 MHz 710.7 MHz 711.7 MHz Hi ghest fc, QAM 715.6MHz 715.4 MHz 715.1 MHz Low est fc, QPSK 710.3 MHz 711 MHz 712 MHz Hi ghest fc., QPSK 715.6 MHz 715.5 MHz 715.