User's Manual

ManualsBrandsTransCore ManualsElectronicsLocation Monitoring Services Transmitter

Trusted Transportation Solutions

PocketPass™

Installation Instructions

16-0042-001 Rev A2

PocketPass is designed for mounting to a vehicle's interior windshield surface using 3M™

Dual Lock™ strips. This mounting method provide for easy mounting and removal when

portability is needed.

General Installation Information

Metallized Windshields

Some vehicle windshields contain a metallic treatment that could prevent an interior windshield-mounted

device from working correctly. If you have a vehicle with a metalized windshield, contact your local

customer service center for more information. If your vehicle’s metalized windshield has a metal-free

zone, it is typically located near the rearview mirror.

Required Supplies

• PocketPass

• Commercial glass cleaner and paper towels

PocketPass Installation and Removal Procedures

Installing the PocketPass with Dual Lock Strips

1. Choose the location for your PocketPass (Figure 1). It should be mounted as close to the bottom

center of the windshield as possible; at least 3 inches away from the windshield frame or

dashboard, and not behind the windshield wipers.

Figure 1 –

Summary of content (6 pages)

PAGE 1
PocketPass™ Installation Instructions 16-0042-001 Rev A2 PocketPass is designed for mounting to a vehicle's interior windshield surface using 3M™ Dual Lock™ strips. This mounting method provide for easy mounting and removal when portability is needed. General Installation Information Metallized Windshields Some vehicle windshields contain a metallic treatment that could prevent an interior windshield-mounted device from working correctly.
PAGE 2
Installation Instructions 2. Clean and dry the interior windshield surface completely before affixing the Dual Lock strips. The windshield temperature must be at least 68ºF (20ºC) for optimum bonding. 3. Peel the backing off the Dual Lock strips (Figure 2). Leave both sides of the Dual Lock strips pressed together to ensure the strips will align between the tag and windshield. Apply the PocketPass to the windshield using moderate pressure.
PAGE 3
PocketPass Figure 3 – 2. Remove the old batteries and replace them with AAA batteries according to the diagram on the inside of the battery compartment. Figure 4 – 3. Close the cover and slide it back into place. You should hear a soft snap when the cover is in the correct position. 4. You will see a brief audio/visual sequence display as the tag powers up. If there is an ASTM V6 AV code stored, the sequence will take up to 15 minutes to complete. 5. Reinstall the tag on the windshield.
PAGE 4
Installation Instructions NO UNAUTHORIZED MODIFICATIONS STATEMENT Caution: This equipment may not be modified, altered, or changed in any way without permission from TransCore, LP. Unauthorized modification may void the equipment authorization from the FCC and will void the TransCore warranty. RADIO FREQUENCY INTERFERENCE STATEMENTS Note: This device complies with Part 15 of the FCC Rules and the Industry Canada Licence-Exempt RSS Standards.
PAGE 5
PocketPass Page 5
PAGE 6
For more information: Sales Support 800.923.4824 Technical Support 505.856.8007 transcore.com Trusted Transportation Solutions © 2015 TransCore L.P. All rights reserved. TRANSCORE and TRANSSUITE are registered trademarks, and are used under license. All other trademarks listed are the property of their respective owners. Contents subject to change. Printed in the U.S.A.