Installation Instructions

ManualsBrandsTransCore ManualsElectronicsMobile Non-multilateration Transponder LMS Tag

Trusted Transportation Solutions

16-6200-035 Rev X2 7/22

ASTM Mini Hardcase

TransCore’s ASTM Mini Hardcase is an ASTM radio frequency identiﬁcation

(RFID) tag for use on the 407 ETR in Toronto.

General Installation Information

Metallized Windshields: Some vehicle windshields contain a metallic treatment that could prevent an

interior windshield-mounted tag from working correctly. If you have a vehicle with a metallized windshield,

you may need to install an exterior tag on your vehicle instead of the interior windshield-mounted tag.

Contact your local tag customer service center for more information.

Metal-Free Zone: Some vehicles with metallized windshields have a metal-free zone, usually located near

the rearview mirror. If your windshield has this zone, center the tag in that area and follow the installation

instructions listed in these pages.

Tinted Windshield: Some vehicles have a metallic tint across the top of the windshield that might interfere

with reading the tag. If your windshield has this metallic tint, install the tag at least 2 inches (5.1 cm) below

the tinted area. Nonmetallic tint does not aect tag performance.

Metal Sun Visors: Some vehicles have an exterior-mounted sun visor that might interfere with reading the

tag. If your vehicle has this visor, mount the tag at least 2 inches (5.1 cm) below the visor.

Summary of content (6 pages)

PAGE 1
ASTM Mini Hardcase Installation Instructions 16-6200-035 Rev X2 7/22 TransCore’s ASTM Mini Hardcase is an ASTM radio frequency identification (RFID) tag for use on the 407 ETR in Toronto. General Installation Information Metallized Windshields: Some vehicle windshields contain a metallic treatment that could prevent an interior windshield-mounted tag from working correctly.
PAGE 2
Installation Instructions Tag Installation and Removal Procedures The ASTM Mini Hardcase tag is designed for mounting to a vehicle’s interior windshield surface with 3M™ Dual Lock™ mounting strips. Required Supplies • ASTM Mini Hardcase Tag • Commercial glass cleaner and paper towels Installing the Tag Choose the location for your tag (Figure 1). The tag should be mounted approximately 1 inch (2.54 cm) below the rear view mirror post.
PAGE 3
ASTM Mini Hardcase 2. Hold the tag so that the printed text or image is right side up and facing toward you ( Figure 3). Press the tag against the windshield and hold for 10 seconds. Note: When installing the tag using the mounting strips for the first time, leave the tag in place for at least 24 hours to allow the adhesive to cure. Figure 3 Correct Tag Orientation TA0444-002 Removing the Tag To remove a tag installed with mounting strips from the windshield, grip the tag at the top and bottom sides.
PAGE 4
Installation Instructions REGULATORY INFORMATION This device is a mobile transmitter that uses an internal antenna to send radio frequency (RF) energy for data communications. The device emits RF energy below the published limits when operating in its maximum output power mode. To comply with RF exposure compliance requirements, the device must be installed and operated with a minimum of 20 cm (7.9 inches) between the device and your body. The device should not be used in other configurations.
PAGE 5
PAGE 6
For more information: Sales Support 800.923.4824 Technical Support 505.856.8007 transcore.com © 2022 TransCore L.P. All rights reserved. TRANSCORE is a registered trademark and is used under license. All other trademarks listed are the property of their respective owners. Contents subject to change. Printed in the U.S.A.