MTX-2500™ 2.
Trango Systems, Inc. FCC ID: NCYMTX2500MP (Canada pending) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, incluing interference that may cause undesired operation. ¤ M-MTX_A.p65 All rights reserved. © 2001 Trango Systems, Inc. 9939 Via Pasar, San Diego CA 92126-4559 +1 858-653-3900 techsupport@trangosys.com www.trangosys.
The MTX-2500™ Wireless Video/Audio Transmitter Congratulations on choosing the MTX-2500 video/audio transmitter from Trango Systems. When unpacking the unit, verify that the following items are present: • MTX-2500 transmitter • attached omnidirectional antenna • combination input cable with connectors for power (nine-volt battery) and audio (RCA) If any items are missing, notify your sales representative.
Setup Guide 1 Prior to connecting the MTX-2500, verify proper operation of video source and monitor/video recorder using a directly connected cable. MONITOR VIDEOCAMERA or CAMCORDER CABLE 2 Connect the power/audio cable to the MTX-2500 and attach a ninevolt battery. Note: the unit will operate between 6 and 13.8 volts DC, if you desire to use a different power source.
the leads for positive and negative voltages are attached correctly, otherwise the unit will not function. $ Channel DIP switch. This switch controls the transmitter channel. Remember to change the receiver (either Eagle PLUS™ or Stingray™) channel as well, since it is not automatically changed when the transmitter channel is changed. 60° 4 45° Move and adjust the orientation of the MTX-2500 and receiver until the best picture is obtained.
• If operating more than one system in an area, set the channels as far apart as possible on each system (i.e. system A uses channel 1, system B uses channel 4). Transmission Range The system is designed to operate up to three hundred feet in most office environments, and two thousand feet line-of-sight. Buildings with thick steel-reinforced or concrete inner walls will reduce the maximum obtainable range. Service If the unit ever needs repair service, contact your Trango Systems, Inc.
Troubleshooting Interference. If interference such as lines in the pictures are observed, changing the channels may cure the problem. Also, AC generators in close proximity to the transmitter or receiver may cause lines in the picture. Move the unit away from the source of the interference. Note: microwave ovens may interfere with this product. No Picture. Check that the transmit and receive channels are set the same. Verify all connectors are tight. Poor Picture Quality.
Trango Systems technical support online: www.trangosys.