USER MANUAL VHF HIGH BAND HIGH POWER MOBILE RF POWER AMPLIFIERS 3370 SAN FERNANDO ROAD, UNIT 206 LOS ANGELES, CALIFORNIA 90065 L-PA3-1FE-H-U/H8
GENERAL SPECIFICATIONS VHF High Band High Power Mobile RF Amplifier FREQUENCY RANGE: 150 - 174 MHz BANDWIDTH: 24 MHz OUTPUT MODE: FM L E D O M RT EU WP ON PI T RU EP WT OU PO LT ANN NEI IRA MR R OUD NC E S U F E F 1 3 A P W 0 4 0 2 W 0 4 1 0 7 S P M A 4 1 S P M A 0 3 OPERATING TEMPERATURE RANGE: -30° to +60° Celsius OPERATING VOLTAGE: Minimum 11VDC, Maximum 15VDC as measured at the DC Input connector. Rated voltage is 13.8VDC and all specifications are given at 13.8VDC.
General Specifications (cont.) RECEIVER PATH INSERTION LOSS: 1dB maximum (150-174 MHz) HARMONIC AND SPURIOUS EMISSIONS ATTENUATION: Models meet or exceed FCC requirements. CONNECTORS: S0-239 (UHF) on input and output. Cinch 4 pin (male) DC input. **FUSING: If an external fuse is required, refer to the table under General Specifications. NOTE This amplifier has been tuned to the frequency specified at the time of order. Broader coverage is available, if specified at the time of order.
FIGURE 1 AMPLIFIER INSTALLATION Page 3
INSTALLATION Amplifier installation is illustrated in Figure 1. Mount the amplifier as close to the antenna as practical. Keep coaxial cable runs short, avoiding sharp bends and pinching. The antenna should be matched to an SWR better than 1.5:1 for best results. Higher SWR will degrade the performance of the amplifier. Mount the amplifier away from sources of heat, and where air can freely circulate around it.
FIGURE 2 DC CONNECTOR WIRING Attach DC input wires in accordance with this diagram. If the wires are too large for the holes, solder them to the sides of the blade. OPERATING PRECAUTIONS CAUTION: This amplifier produces RF voltages that can cause painful and dangerous RF burns. Use caution! Connect and disconnect all RF Connections iwth the DC power and drive power off. DRIVE POWER: RF power transistors, although quite rugged in most respects, are easily damaged by overdrive.
WARRANTY TPL Communications has tested and found this unit to function properly and to operate within the parameters of its stated specifications. TPL Communications warrants that this product is free from defects in material and workmanship. If found defective within five (5) years from the date of purchase, the factory, at its discretion, will either repair or replace the unit at no cost provided that the unit is delivered by the owner to the factory intact.