TownSteel e-Elite 3000 Installation Guide
Table of Contents Package Content 2 Getting Started 3 Door Preparation 4 Step 1 - Latch Bolt & Strike 5 Step 2 - Installing Outside Assembly 6 Step 3 - Installing Backplate 7 Step 4 - Connecting Wires 8 Step 5 - Installing Inside Assembly 9 Step 6 - Installing Covers 10 Step 7 - Installing Inside Lever 11 Addendum 12 Exploded View 13 Troubleshoot 14 1
Package Content Parts in the box Outside Assembly Backplate Inside Assembly Inside Lower Cover Inside Upper Cover Collar Bearing Ring Inside Lever Latch Bolt & Screws Strike & Screws Backplate Screws Inside Assembly Screws Inside Cover Screw Additional Parts Included
Getting Started Tools needed for lock installation Phillips Screw Driver (Not included) Lever Removal Tool Torx Wrench Note: Do not use a power drill for installation of lock - it can damage the lock.
Door Preparation Prepare door and jamb per template provided. The backset is the dimension from the edge of the door to the centerline of the lock. Important: Door stop is where the door will stop when normally operated. The stop includes any gasket, smoke seal, or bumpers. The position of strikes are to be measured taking this into account.
Step 1 Install the latch bolt and secure with 2 screws. Install strike and secure with 2 screws. Note: A right hand (RH) lock will be depicted in the following guide - for left hand (LH) install opposite. During installation keep the door open. Do not use power tools for assembly or you can potentially damage the door.
Step 2 Install the outside lock assembly in the cutout. Guide the wire harnesses through the cutout. Line up the retractor on the lock body with the latch tail piece. Tighten the latch screws. Note: Do not pull or pinch the wire harnesses.
YW1930
Step 4 Plug in the wire harnesses where indicated on the inside assembly.
Step 5 Install inside assembly with 4 screws. Do not pinch wires. Install the 4 AA alkaline batteries provided. The keypad will light up green and the motor will run.
Step 6 Install inside lower cover first. Tighten the bearing ring to hold cover in place. Install the inside upper cover - slide down from top secure with screw using the wrench provided.
Step 7 Install the inside lever - ensure the lever is seated and is locked in place. Lever catch is on the side of lever and it should snap into place. Note: Check lock for correct operation before closing the door. See programming guide for help.
Addendum 2. Insert lever removal tool into the lever catch hole and push back the lever catch. Lever catch hole 3. Remove lever.
Exploded View 1 x Inside Cover Screw Inside Upper Cover Inside Lever Backplate Bearing Ring Inside Lower Cover 4 x Inside Assembly Screws Inside Assembly Outside Assembly Collar 2 x Backplate Latch Bolt Screws 2 x Latch Screws 13
Troubleshoot Problem Keypad does not light up. Cause Batteries are dead. Keypad is locked out due to amount of incorrect codes Solution Replace batteries by removing back cover. Wait 60 seconds and try again. Check wire connection. Issues retracting latch. Not fully plugged in wires or pinched wires. Latch tail piece did not fully engage lock body retractor. Keypad lights up but motor does not respond. Motor wire is not fully plugged in or has been pinched. Undo the back cover and inside assembly.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.