Operating Instructions

TowBrite Inc.
www.towbrite.com
613-366-1584
[e-mail]
Quality Wireless Tow Lights
Made in Canada
FCC ID: 2AWK3-TBR433TX IC: 26388-TBR433TX
Model: TBR433TX
PMN: TowBrite 433mhz TX
Manual
TowBrite 433mhz TX
Operating Instructions
1. Each TowBrite Wireless transmitter is encoded with a unique ID to prevent cross talk between
different devices.
2. Plug the transmitter into your vehicle or hardwire it to your vehicle as per the instructions
provided by your vehicle manufacturer. Take note that the transmitter can only accept 12V
power to the inputs and ground. Constant power is not required.
3. To pair the transmitter to a compatibly receiver
a. Connect the transmitter into your vehicle
b. Turn on the left turn signal of your vehicle
c. Power on the receiver
d. Wait for the boot up sequence to take place on the receiver.
e. Wait until the receiver starts flashing in sync with the transmitter.
f. Note: This pairing is one-way, so a single transmitter can be paired with multiple
receivers if desired.
These devices comply with part 15 of the FCC rules , as well as the Canadian Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:: (1)
the device should not cause harmful interference; and (2) the device must accept any interference
received. Including interference that may cause poor operation
Ce matériel est conforme à la partie 15 des règles FCC [et aux critères d 'exemption des licences
industrielles canadiennes (RSS)].L 'opération doit satisfaire aux deux conditions suivantes: 1) l'
équipement ne doit pas causer d 'interférences nuisibles; et 2) l' équipement doit accepter toute
interférence reçue, y compris toute interférence pouvant conduire à des opérations indésirables
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.