TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-R2312 CD-RW/DVD-ROM COMBINATION MOBILE DRIVE USER MANUAL
CONTENTS Introduction..............................................................................1 Setup ........................................................................................3 Using the CD-RW/DVD-ROM Combo Drive ............................4 Troubleshooting.......................................................................6 Specifications ..........................................................................7 Drive Connectors......................................................
INTRODUCTION – SD-R2312 General Features CD-RW disc write/rewrite at 4X and 10X CD-R disc write at 8X – 24X Lead (Pb) Free Printed Circuit Board 3-way Disc Eject (eject button, software, emergency eject hole) Average Access Time CD DVD-ROM DVD-RAM 90ms 100ms 170ms Horizontal or Vertical Mount 2MByte Buffer Playback interchangeability for CD-ROM and DVD-ROM discs Regionalization (RPC2 compliance) (DVD) BUS Interface ATAPI Types of Disc Formats Supported - Write CD-R, CD-RW: CD-DA, CD+(E)G, CD-MIDI, CD-
Front Panel Figure 1.SD-R2312 CD-RW/DVD Combo Drive Front Panel Loading Tray Load disc using tray. Busy Indicator The LED lights green or amber when the drive is operating (LED is amber when drive is writing.) Eject Button The Eject button is used to open the disc tray so you can install or remove a disc. Emergency Eject Hole The emergency eject hole is to be used only when the Loading Tray will not open when Eject button is pressed.
SETUP – SD-R2312 Toshiba recommends that only trained professionals install this CD-RW/DVD-ROM Combo drive into your laptop/notebook. Installation Notes • • • • • The SD-R2312 CD-RW/DVD-ROM Combo drive has no jumpers that need to be set Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position), 30° (drive with volume control in up position). When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive.
USING THE CD-RW/DVD-ROM Combo Drive – SD-R2312 Drive Operation Inserting Media To insert media perform the following steps: Figure 1.Inserting Disc 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray. 2. Place media disc into drive's loading tray, and lightly press down on the inner portion of the disc. 3. Gently close the disc tray. Removing Media To remove media disc from the drive, perform the following steps: 1.
Regional Coding Region Protection Coding (RPC) of DVD Discs: this feature is supported on DVD Players and is used with DVD-Video Discs (i.e. movies). Currently, the motion picture industry has divided the world into different regional "zones." These regions or "zones" correlate to the regional markets into which the motion picture industry releases movies. Simply put, RPC Codes are placed on Movie Discs marketed throughout the world based on the region of the world where they are being sold.
TROUBLESHOOTING – SD-R2312 Solution Problem Disc tray cannot be opened • • Check that there is power to drive. Use Emergency Eject instructions to open tray. Drive is not recognized by system • Is the drive connected properly? Are all cables plugged in properly (e.g. Power Cable, Interface Cable and Audio Cables).
SPECIFICATIONS –SD-R2312 General Interface: ATAPI Compatible CD-RW/DVD-ROM Standard - Write: Write Formats: CD-R, CD-RW: Disc at once, Track at once, session at once, Packet Write Write Disc: CD-R, CD-RW: CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, MIXED MODE CD, CD-I, CD-I BRIDGE (Photo-CD, Video-CD), Multisession CD (Photo-CD, CD-Extra, Portfolio) Compatible DVD-ROM Standard - Read: DVD: CD-ROM: DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R (ver 1.0 & 2.0, read) DVD-RW (ver 1.
Performance Rotational Speed DVD (Single) DVD (Dual) DVD-R, DVD-RW DVD-RAM (ver 2.1) DVD-RAM (ver 2.1) CD-ROM, CD-R Video-CD, CD-DA CD-DA CD-RW (read) - normal CD-RW (read) - high speed CD-R (write) CD-RW (write) CD-RW (write) - high speed 4,670rpm (3.3 - 8X) 3,792rpm (2.5 - 6X) 2,240rpm (1.7 - 4X) 1,400 - 3,300rpm (1X) 2,200 – 4,800rpm (2X) 5,100rpm (10.3 - 24X) 1,200 - 2,000rpm (4 - 6X) 2,350 - 4,300rpm (8.
Environmental Ambient Temperature Operating Storage Shipping Temperature Gradient Operating Storage/Shipping 5° to 50° C (41° to 122° F) -10° to 60° C (14° to 140° F) -40° to 65° C (-40° to 149° F) 11° C /hour (max) 20° C /hour (max) Relative Humidity Operating Storage/Shipping 8% to 80% 5% to 95% (wet bulb 40° C max) Vibration Operating (5 to 500 Hz) (read) Operating (5 to 500Hz) (write) Non-operating (10 to 500Hz) Transporting (with packing) (10 to 25 Hz) 2.45 m/s2 (0.25G) (O-P) 2.45 m/s2 (0.
Drive Connectors –SD-R2312 Figure 1.SD-R2312 DVD Writeable Drive Rear Panel – Connector A 50-pin ATAPI interface connector is found at the rear of the SD-R2312 CD-RW/DVDATAPI Connector ROM Combo drive. Connecting cable should use Japan Aviation Electronics Industry Limited KX14-50Series L or equivalent connector. Table 1.Interface Pin Assignments PIN NO.
