Installation instructions

For 1 tube luminaire: For 2 tubes luminaire:

The LED replacement starter in the package is mandatory for operation and safety

Please read this document carefully. If you are uncertain about a step, please contact an

electrician for support.

This information is provided for your convenience. Toshiba disclaims liability for any direct, indirect

or damages in case of installation performed either not according to these instructions, not

performed by an electrician or in case of conversion of the luminaire.

If the existing luminaires is operated more than 8 years, TOSHIBA recommends a replacement of

whole luminaires to avoid long aged deterioration of lamp holders etc.

In case a parallel power factor compensation capacitor is used in the luminaire, it will reduce

the power factor. Consider that power factor could need to be adjusted according to local

regulations.

Circuit diagram of retrofitted luminaire:

Retrofitting in a CCG luminaire

The luminaire can still be used for fluorescent lamps when the normal starter is reinstalled.

The certification of luminaire remains valid.

Installation Instructions:

• Make sure if supply voltage and frequency fall within product rating on lamp/package

• Make sure that the supply voltage is disconnected

• Remove the conventional lamp

• Replace the conventional starter to the LED replacement starter delivered with

TOSHIBA LED tube

• Insert the TOSHIBA LED tube into lamp holders and check the light distribution angle

TOSHIBA LED TUBE INSTALLATION OPTIONS

TOSHIBA LED TUBE INSTALLATION OPTIONS_ver1.0

LED tube

LED replacement starter

CCG

LED tube

LED replacement starter

CCG

LED replacement starter

CCG

PAGE 1
Please read this document carefully. If you are uncertain about a step, please contact an electrician for support. TOSHIBA LED TUBE INSTALLATION OPTIONS This information is provided for your convenience. Toshiba disclaims liability for any direct, indirect or damages in case of installation performed either not according to these instructions, not performed by an electrician or in case of conversion of the luminaire.
PAGE 2
. Direct line voltage connection If ECG/CCG (ex, for 2 fluorescent tubes) luminaire is retrofitted or the losses of CCGs should be eliminated, rewiring of the luminaire is mandatory. The installation must only be done by a qualified electrician. All the security instructions that follow have to be respected and kept as guidance for future maintenance use. Responsibility of technical and safety consequences of the re-wired luminaire is shifted to the party carrying out the wiring changes.