User Guide

ManualsBrandsToshiba ManualsOther(HDD1642)

TOSHIBA AMERICA INFORMATION SYSTEMS

STORAGE DEVICE DIVISION

IRVINE, CALIFORNIA

MK3008GAL (HDD1642)

1.8-INCH HARD DISK DRIVE

USER MANUAL

Summary of content (9 pages)

PAGE 1
TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA MK3008GAL (HDD1642) 1.
PAGE 2
CONTENTS Introduction..............................................................................1 Setup ........................................................................................2 Using the HDD .........................................................................3 Specifications ..........................................................................4 Drive Connectors.....................................................................
PAGE 3
INTRODUCTION – MK3008GAL (HDD1642) HARD DISK DRIVE General Features 1 • 1.
PAGE 4
SETUP – MK3008GAL (HDD1642) HARD DISK DRIVE Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive. Figure 1. MK3008GAL Side View Installation Notes • Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N.
PAGE 5
USING THE HARD DISK DRIVE – MK3008GAL (HDD1642) HARD DISK DRIVE Backing up Data Files To avoid data loss, regularly back up the data files on the hard disk drive.
PAGE 6
SPECIFICATIONS – MK3008GAL (HDD1642) HARD DISK DRIVE General Model Interface MK3008GAL (HDD1642) ATA-6 Functionality Formatted Capacity Rotational Speed Avg. Rotational Latency Spin-up Time Buffer Seek Time Average Maximum Internal Transfer Rate Host Transfer Rate Ultra DMA mode PIO Mode Interleave Factor 30.0GB 4,200rpm 7.14/ms 3.sec (typical) 2MB 15 26 131.1 ~ 283.3 Mbits/sec (max) 100Mbytes/sec 16.
PAGE 7
Physical Height Width Depth Weight 0.0196” (5.0mm) 2.13" (54.0mm) 3.09" (78.5mm) 1.69oz (48g) typ Regulatory The drive satisfies the following standards: Underwriters Laboratories (UL) 1950 Canadian Standard Association (CSA) C22.2 No.
PAGE 8
DRIVE CONNECTORS – MK3008GAL (HDD1642) HARD DISK DRIVE Figure 1.
PAGE 9
Interface Signals DRIVE INTERFACE SIGNALS PIN SIGNAL PIN SIGNAL 1 RESERVED 2 RESERVED 3 - RESET 4 GROUND 5 DD 7 6 DD 8 7 DD 6 8 DD 9 9 DD 5 10 DD 10 11 DD 4 12 DD 11 13 DD 3 14 DD 12 15 DD 2 16 DD 13 17 DD 1 18 DD 14 19 DD 0 20 DD 15 21 GROUND 22 DMARQ 23 GROUND 24 -DIOW/STOP 25 - DIOR/ - HDMARDY HSTROBE 26 GROUND 27 IORDY/ - DMARDY/DSTROBE 28 GROUND 29 DMACK 30 INTRQ 31 DA1 32 - PDIAG/-CBLID 33 DA0 34 DA 2 35 - CS0 36 CS1 37 - DAS