TEC Wireless I A N Module for B-SP2D Series TEC-WLM- R TOSHleA TEC CORPORATION
Procedure of attaching T E C - ~into B*P2D series Caution: To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm (8 inches) must be maintained between the antenna for the Wireless LAN Card when installed in the host printer and all persons. . ---. Three are removed an$ a-bottom cover is remove& T E H U - f t is attached in the space, the bottom cover according to a boss.
Safety Precautions EO-m52 Precautions for Handling of Wireless Communication Devices Bluetooth* Module: TEC-BTM-R (GH30 model) Wireless LAN Module: TEC-WLM-R (GH40 model) Trade Mark Bluetwth i s a trademark owned by Bluetoath SIG, Inc. and is used by TOSHIBATEC CORPORATIONunder license. Cautions General For all counln'es and areas This pmdud is ae se lrv i wmmunication device, and the use of this pmdud is restricted to the foliowing wuntries or areas.
safety Precautions II mI-Po52 For USA This device camolieswith Part 15 of the FCC R jjules. Operation is subject to the following Lwo conditions: (0this dcvicc may n d c a ~ s chaGlul oot~dcrcncc,and (21 Ul's device mLst a m p 1 any mterference reeked, incl~ding inlerier~n~ethat may wusc unoesired opemtlon Changes or modification notexpresslyapprovedby manufacturerfor compliance could void the user's authorityto aperatethe equipment.
Safety Precautions EOI-~D~~ Do not disassemble, modify, or repair the produd Doing so may cause injury. Also, modScation is against lhe Laws and Regulations for Radio Equipment Please ask yourTOSHlBATEC sales agentfor repair. Precautionin use This produd communicates with other devices by radio. Depending on lhe installation location, orientation, envimnment, etc., ita communication performance may deteriorateor devices installed near by may beaffected. Keep awayfmm a microwave.