TEC BluetoothTM Module for B-415 Series TEC-BTM Installation Manual
Precautions for Handling of Wireless Communication Devices BluetoothTM Module: TEC-BTM n Trademark The Bluetooth is a trademark owned by Bluetooth SIG, Inc. and is used by TOSHIBA TEC Corporation under license. n Cautions General This product is a wireless communication device, and the use of this product is restricted to the following countries or areas. If the product is used in the countries or areas other than the following, you may be punished according to the laws of those countries or areas.
For safety Do not disassemble, modify, or repair the product. Doing so may cause injury. Also, modification is against the Laws and Regulations for Radio Equipment. Please ask your TOSHIBA TEC sales agent for repair. Do not use the product in locations where the use is forbidden, for example, in an airplane or a hospital.
Procedure of attaching TEC-BTM into B-415 series 1) Open the media cover and raise it to its full open position. 2) With a small tool, such as a pin punch or a jewellers screwdriver, push to release the left and right hooks that secure the head cover to the media cover.
3) Take off sensor PCB with small ribbon cable (sensor FPC) from head cover. sensor FPC Take off open cover 4) Attach the TEC-BTM into specified space near MAIN PCB. FPC ribbon cable MAIN PCB TEC-BTM 5) Connect the both side of FPC ribbon cable to the connector of TEC-BTM and the CN3 of MAIN PCB. 6) Assemble the parts according to reverse procedure.
PRINTED IN JAPAN