User's Manual

ManualsBrandsToshiba TEC ManualsElectronicsBluetooth modular transceiver

Regulatory statement:

This device complies with Part 15 of the FCC Rules as well as Industry Canada 

requirements. Operation is subject to the following two conditions: (1) this device may 

not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.Operation is 

subject to the following two conditions: (1) this device may not cause interference, and 

(2) this device must accept any interference, including interference that may cause 

undesired operation of the device. To prevent radio interference to the licensed service, 

this device is intended to be operated indoors and away from windows to provide 

maximum shielding. Equipment that is installed outdoors is subject to licensing.

Summary of content (6 pages)

PAGE 1
Regulatory statement: This device complies with Part 15 of the FCC Rules as well as Industry Canada requirements. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
ENGLISH VERSION E01-33014 7. LOADING THE LABEL 7.1 How to load the liner backed label roll 8. Push down the media cover until the two cover release catches click and they are put in the lock position. NOTE: If the media cover is open and unlocked, an error will result and the printing will not be performed. Fig. 7-6 9. In case of the strip issue, pull out the top of the liner of the label roll to eliminate the slack from the label roll. [How to remove the liner backed label roll] 1.
PAGE 3
ENGLISH VERSION EOl-33014 7. LOADING THE LABEL ;‘.I How lo load the lmer backed label rot1 ‘* .-,,, 5. 6. Load the liner backed label roll WM. Slide the paper guide (R) to accommodate the label roll width, and then push the release lever downward to fix the paper guide (R). NOTE: Before fixing the paper guide (I?), make sure that the label roll rotates smoothly without wobble. Label Roll - Paper Guide (R) fielease Lever --‘- Fig. 7-3 7.
PAGE 4
ENGLISH VERSION EOl-33014 7. LOADING THE LABEL 7.1 HOW KI load the lmer backed label roll 7. LOADING THE LABEL 7.1 How to load the liner backed label roll 1. 2. 3. Place the printer on the level surface as shown below. the media cover, press the two cover release catches in the directions of the arrows. Open the media cover by pushing up the strip cover. To unlock 0 Media Cover Release catch Media Cover Medi a Cover Releace catch Fig. 7-l 4.
PAGE 5
PAGE 6