User's Manual

ManualsBrandsTOSHIBA TEC Singapore ManualsComputers & AccessoriesDot Printer

Rear Front

Left Side View

1. Power Switch

2. Cover Latch (to secure top cover)

3. Forms Tractors (to hold and feed continuous forms)

4. Paper Guides (to guide single sheets)

5. Paper Exit Slot and Tear Edge

6. Top Cover – Rear

7. Single Sheet Tray (Shown in down Position)

Bottom View

8. Interface Connectors (or Wireless Adapters if installed)





























Vertical Position

Bottom View





Summary of content (5 pages)

PAGE 1
Rear Front Left Side View 1. Power Switch 2. Cover Latch (to secure top cover) 3. Forms Tractors (to hold and feed continuous forms) 4. Paper Guides (to guide single sheets) 5. Paper Exit Slot and Tear Edge 6. Top Cover – Rear 7. Single Sheet Tray (Shown in down Position) Bottom View 8.
PAGE 2
Operations of the Control Panel This section summarizes status indications and operations of the control panel in Normal mode. For details on Set-Up mode, see Chapter 4, “Using Set-Up Mode.” Normal mode operation includes everyday operations, such as paper handling, font selection, macro selection, and protocol selection. The first table lists basic states represented by the Ready and Fault indicators. The second table lists Normal mode operations and required user response.
PAGE 3
Operation Required Conditions *1 Ready Printing *2 Required Action Fault Load continuous forms paper — Not printing On Press FF/LOAD. Load single sheet paper — Not printing On Paper is automatically detected and advanced (auto-loading) when it is first inserted. In this mode, if the FF button is pushed, the inserted sheet will be ejected from the printer and the Fault LED will light, indicating paper out condition. Feed paper a page — Not printing Off Press FF/LOAD.
PAGE 4
Ready Printing *2 Fault Enter Top-of-Form Adjustment mode—Not printing Off Press SETUP/EXIT and ALT. Use the adjustment temporarily Off — Off Press ALT-NEXT. Use the adjustment permanently Off — Off Press SETUP/EXIT. Clear the adjustment Off — Off Press ALT-PREVIOUS. Enter Set-Up mode N/A N/A N/A Turn power on while pressing SETUP/EXIT. Move cursor to select Off Not printing Off Press NEXT or PREVIOUS button. Off Not printing Off Press NEXT or PREVIOUS button.
PAGE 5