User's Manual
p
p
p
p
p
p
p
p
(
p
p
(
(
pp
p
p
p
p
p
p
,
u
c
g
r
A
乡
o
心
g
p
s
勺
p
p
p
．
p
p
p
p
p
pp
p
p
p
p
p
p
p
抓
u
w
『
g
p
m
w
a
h
g
e
w
”
5d
3
』
p
p
p
p
p
勹
t
立
尸
－
』沁
＼
二
I
、
『尸
t
'
卢
穸
p
p
p
p
pp
p
p
p
p
(
p
(
p
p
p
p
p
p
p
p
p
(
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
三
pp
B
Date
20180806
ALPI0013A
QAndobil
Automatic Car Mount
Wireless Charger
User Manual
This device complies with part 15 and part 18 of the FCC Rules. Operation is
Subject To the following two conditions:
(1) This device may not cause harmful interference, and (2) this devicemust
accept any interference received, including interference that may cause undesired
operation. Changes or modifications not explicitly approved by the partyresponsible
for compliance could void the user's authority tooperate this equipment.
Note: this equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 and part 18 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and canradiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference toradio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged totry to correct the interference by one or more of the following
measures:
--- Reorient or relocate the receiving antenna
--- Increase the separation between the equipment and receiver.
--- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
--- Consult the dealer or an experienced radio/TV technician for help.
Theequipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
This device complies with Part 18 of the FCC Rules. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Increase the separation between the equipment and any other radio device.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.