User's Manual

ManualsBrandsToro ManualsElectronicsLight Logic Plus LPlus /SMRT Logic SMRT-T SMRT-I

Add a Location

Light Logic PLUS account must be set up.

1. Point browser to www.lightlogicplus.com.

2. Click the Register link.

3. Fill out all elds and press Register.

4. A verication link will be e-mailed to the specied

e-mail address. Click the verication link in

the e-mail. You will be taken to the Light Logic

website. Click the Complete Registration link.

5. You will be taken to the sign in page.

Enter e-mail address and password

then click Sign In.

Now we need to add the location of the

Light Logic PLUS.

1. Click + Add a Location.

2. Fill out the Name and Description elds. For

example, “Home” and “Primary residence”

respectively.

3. On the Google Maps map (Figure 1), enter

desired address into the Address eld or drag the

location of the red arrow to the desired location.

4. Scroll down. Enter a PIN for the Light Logic

PLUS to enable manual operation. PIN must

match the PIN of the Remote (LMRT) if a remote

is owned.

5. Enter a value (ranging from -120 minutes to 120

minutes) for the Dawn and Dusk Osets (Figure

2). A negative oset will be earlier than the

calculated dusk/dawn; a positive oset will be later.

6. Click Submit.

Add a Second Location

It is possible to add another location: a vacation

house for example. Repeat steps 1-7 above with a new

Name.

Edit a Location

1. Click the blue gear icon

to the right of the

location name.

2. A contextual menu appears. Select Edit Location.

3. Follow steps 2-7 as above.



Figure 1

Figure 2

Light Logic Plus User Manual

Model: LPlus

Summary of content (4 pages)

PAGE 1
Light Logic Plus User Manual 1 Register Light Logic PLUS account must be set up. 1. Point browser to www.lightlogicplus.com. 2. Click the Register link. 3. Fill out all fields and press Register. 2 Model: LPlus Add a Location Now we need to add the location of the Light Logic PLUS. 1. Click + Add a Location. 2. Fill out the Name and Description fields. For example, “Home” and “Primary residence” respectively. 3.
PAGE 2
3 4 Add Scene/s After adding a location, a default Scene is added to the Light Logic. The default scene turns on every day of the week from Dusk to 10pm. To edit the Scene: Add Hardware Connecting the Light Logic PLUS 1. Connect Ethernet cable from internet router to RJ45 port on back of PLUS. 1. Click the blue pen by “Scene 1” text. Position Antenna and Unit as Shown. 2. Plug in the AC adapter. 2.
PAGE 3
Add LPCUs to the PLUS We need to add LPCUs at this time. LPCUs must be added one at a time. 1. Press the Activate discovery mode button. Edit Light Logic Equipment Mouse-click the blue pencil icon to edit LPCU description or change scene assignment. Delete Light Logic Equipment Mouse-click the blue trashcan icon to delete a LPCU. 2. You will be prompted to press the button on the LPCU to add. Go to the LPCU and press the button. 3. Give the detected LPCU a description and assign it to the desired scene.
PAGE 4
FCC Statement and Caution - FCC ID: OF7SCG This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.