Addendum

ManualsBrandsToro ManualsCompactorsToro 68039

FormNo.3388-998RevA

TR-34DTrenchRoller

ModelNo.68039—SerialNo.314000001andUp

Addendum

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

TheengineexhaustfromthisproductcontainschemicalsknowntotheStateofCalifornia

tocausecancer,birthdefects,orotherreproductiveharm.

Important:Thisaddendumdescribeshowtoconnectthebatterycableofyourmachine.

OpeningtheFrontandRear

HoodsoftheMachine

NoPartsRequired

OpeningtheFrontHood

1.Atthefronthood,pivotthelatchhandleforthehood

totheverticalposition(Figure1).

G019041

Figure1

1.Fronthood5.Rearhood

2.Latchhandle(stowed)

6.Hoodclip

3.Latchhandle(vertical)

7.Rearhoodopening

4.Fronthoodopening

2.Rotatethelatchhandleclockwise(Figure1).

3.Graspthelatchhandletightlyandpulluprmlyto

unseatthehoodfromthehoodclips(Figure1).

4.Rotatethehoodup(Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUS

AllRightsReserved

*3388-998*A

Summary of content (4 pages)

PAGE 1
Form No. 3388-998 Rev A TR-34D Trench Roller Model No. 68039—Serial No. 314000001 and Up Addendum WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Important: This addendum describes how to connect the battery cable of your machine.
PAGE 2
Opening the Rear Hood 2. Align the clamp of the negative (black) cable to the negative post of the battery (Figure 2). Note: Ensure that the forward hood is open before opening the rear hood. 3. Fully seat the terminal onto the post (Figure 2). 4. Torque the nut (Figure 2) and the T-bolt for the negative cable clamp to 678 to 791 N-cm (60 to 70 in-lb). 1. Grasp the front edge of the rear hood. 2. Pull up firmly on the hood to unseat it from the hood clips (Figure 1). 3. Rotate the hood up (Figure 1).
PAGE 3
4 Closing the Rear and Front Hoods on the Machine No Parts Required Closing the Rear Hood Note: If the rear hood and the front hood are open, the rear hood must be closed before closing the front hood. 1. Grasp the forward edge of the rear hood. 2. Rotate the hood down (Figure 1). 3. Push down firmly on the hood to seat it into the hood clips. Closing the Front Hood Note: Ensure that the rear hood is closed before closing the front hood. 1. Grasp the latch handle, and rotate the hood down (Figure 1). 2.
PAGE 4