MODEL NO. 58010 â & UP MODEL NO. 58110 â MODEL NO. 58210 â OWNER'S (5 HP) MANUAL 3, 4 AND 5 HP TILLERS SAFETY INSTRUCTIONS CAUTION: This tiller is engineers and tested to offer reasonably safe and effective service, provided it is operated in strict accordance with these instructions. FAILURE T0 DO S0 MAY RESULT IN PERSONAL INJURY, TRAINING 1. Never allow children o operate a tiller or adults to operate it without proper instruction. 2.
TABLE OF CONTENTS Page Safety Instructions . .o Front page Foreword Loose farts Chart . f General Assembly Inspections Preparation Be tore Starting Titling With Filling With Gasoline Check Air Cleaner Know Your Contorts Operating Instructions e e Break-In Procedure Tarting . e Stopping And Emergency S(appmg P Transport Position {Depth Gauge Bar} Lo Depth Gauge Ba Ruse Operating Tips TRENT BRP Tilling Depth Maintenance P Lubrication Servicing Air Cleaner . . oL Changing Engine Qil.
GENERAL ASSEMBLY INSTRUCTIONS 1. Position handle assembly 10 the tiller chassis and secure in piece with four {4} cap screws and knockouts. 2. Install appropriate end af clutch rod through clutch fever snd secure with cotter pin. 3, Place clutch rod into slot in boilermaker and secure with washer and cotter pin, Glens B 4, Hide cable clip and shoulder spacer (shoulder to face outward}) on cap screw, Secure right side of handle 1o right side of handlebar support with capsular assembly and lockout.
OPERATING INSTRUCTIONS BREAK AN PROCEDURE 1l important that the transmission dhd engineer bé broken i properly, Longer life of the wearing parts will resit. Proper barks-in is as follows: 1. Remove the tings from the drive shaft and place o block or brick under the front of the transmission, Ensues that tiller s feel: 2; Disengage clutch fever {neutral. 3. Start Engine [See Starting, page B}, 4, Otter the engine is started, push chute lever fully Forward and.it will interlock engaged.
MAINTENANCE CAUTION: When performing any maintenance on your tiller, LUBRICATION Keep Filter Properly Lubricated 1. Apply a fow drops of SANCHEZ oif to 21 pivot points every fifteen {15) operating hours. Occasionally, place a few pods of oil on the wheel bolts. SERVICING AIR CLEANER Your engine is equipped with & polyurethane toys element, Clean air clanger and re-ail relent every 25 haws under normal conditions. Clean every few hours under extremely dusty conditions, To clean, proceed as follows: 1. .
MAINTENANCE (CONTINUED) SPARK PLUG Use & Champion J8 or equivalent for replacement. Clean and reset tha gep at 030 inches every 25 hoers of operation. Apply light coating of graphite grease on threads before replacing plug. If plug is pitted or cannot be cleaned easily, install @ new plug.
MAINTENANCE (CONTINUED) CARBURETOR ADJUSTMENT {2 HP) Do not make unnecessary adjustments, Factory settings are correct for mast applications, f adjustments are needed, proceed a5 follows: 1. Close power adjusting needle by turning to right {clockwise. Close finger tight only. Forcing will cause dosage. 2. Open one trn {counterclockwise). 3. Close idle adjusting peeled by turning 1o right {clockwise. Close finger tight only. Forcing will cause damage. 4.