Installation Instructions

1. Press the bulb into the ﬁxture contacts.

2. Snap the silver reﬂector into the clear lens.

3. Install the ﬁxture lens/reflector.

Install the clear lens/reflector by pushing down on the lens with

slight pressure while turning the lens clockwise. The tabs on the

lens will snap into the three slots on the fixture. Turn the lens until

the movement stops.

INSTALLATION

GUIDE

FORM NO. 3315-919

MODEL NO. 52201 39000001 & Up

Style Lites™ Floodlights

4. Prepare the stake.

Loop the cable around the channels in the stake. Make certain the

cable is centered around the stake head and is tight. If the cable is

loose, pull the ends to eliminate the slack.

Imprinted

triangles

6. Align the side of the stake with the imprinted triangle to

the top of the fixture head with the imprinted triangle.

5. Make sure the piercing points in the fixture are

straight.

Make sure the brass piercing points in the cable channel at

the base of the ﬁxture are straight. Even a slight bend may

result in contact not being made with the wire.

Misaligned

Piercing

Points

Correct

Piercing

Points

The most important

part of installing the

ﬁxtures is making

sure their metal pins

pierce the wire inside

the cable:

You’ll know they’re

well-aligned and the

wire was pierced

when the light

comes on.

This

Not This

PAGE 1
FORM NO. 3315-919 MODEL NO. 52201 39000001 & Up ® INSTALLATION GUIDE Style Lites™ Floodlights 1. Press the bulb into the fixture contacts. 2. Snap the silver reflector into the clear lens. 3. Install the fixture lens/reflector. Install the clear lens/reflector by pushing down on the lens with slight pressure while turning the lens clockwise. The tabs on the lens will snap into the three slots on the fixture. Turn the lens until the movement stops. 4. Prepare the stake.
PAGE 2
1 o'clock 7. Hold the stake with the cable at an angle of about 30° (1 o'clock) to the floodlight housing as shown. Imprinted triangles on the stake and the fixture Press the stake with the cable down firmly into the piercing points on the fixture. If you have done this correctly, the fixture should light. If it doesn’t, make sure the power pack is on (and the photocell is covered to block light), the piercing points are straight, and try again.