MODEL NO. §1637 39015000 & UP MODEL NO. 8164738015000 & UP FORM NO. 3315366 OPERATOR’S MANUAL 600 AIR RAKE™ 700 IMPORTANT SAFETY INSTRUCTIONS A\ WARNING that you or any other operator of the aj To assure maximum safety, best performance, and to gain knowledge of the appliance, it is essential lance read and understand the contents of this manual before operating the appliance. Pay particular attention to the safely ale! symbol CAUTION, WARNING OR DANGER — “personal safety instruction.
£\ SAFETY INSTRUCTIONS 22. Always be sure of your fating. Keep a firm hold on the handle and walk, never run. Use extra care when cleaning on stairs. 23. Stop the motor and unplug the supply card whenever you leave the appliance, before cleaning the housing, and when making any repairs or inspections. 24. When not in use, store your appliance in a dry place out of the reach of children. 25. Keep all fasteners tight o be sure the appliance is in safe working condition. 26.
ASSEMBLY INSTRUCTIONS TO CONVERT TO A VACUUM (mode 51547 only) (Model 51533 Vacuum Bag Kit Optional for Modal 51537} Note: Turn off unit and unplug from electrical outlet before adding or changing attachments. A\ caution ¢ Motor impeller rotates for a few seconds after blower is turned off. * Rotating impeller can cut or injure fingers. + Never remove inlet caver when motor is operating or when unit is plugged in. 1. Remove the nozzle and blower tube from the blower outlet {Fig. 1}. 2.
ASSEMBLY INSTRUCTIONS SWITCH ANGLED TAB o7 Figure 8 7. Slide upper, middle, and lower tubes together as shown in Figure 9. LOWER MIDDLE UPPER TUBE TUBE TUBE 601 Figure 9 8. Frightening of vac bag over outlet ribs on blower. Pull strap tightly to overlap groveler tabs (Fig. 10). TO CONVERT TO A BLOWER 1. Remove the lower and middle vacuum tubes from the upper vacuum tube {Fig. 9) 2. Grasp the upper vacuum tube firmly {Fig. 11). /) S Figure 11 3.
ASSEMBLY INSTRUCTIONS 4. Remove the vacuum tube (Fig. 13}. Figure 13 5. Position the inlet cover in the slotted ring so that the back pointer on the cover lines up with REMOVE triangle on the housing {Fig. 14} POINTER REMOVE TRIANGLE 7o Figure 14 6. Rotate inlet cover clockwise with some extra force until you hear a “snap.” The black pointer and the "LOCK & RUN" triangle on the housing must line up {Fig. 15).
BEFORE OPERATING SECURING POWER SUPPLY CORD Note: The proper extension cord is a requirement for safe and efficient use of your appliance. Your Toto blower has been designed for use with cord sizes recommended in the Extension Cord Chart below. A\ WARNING » Electric shock can cause injury or death. e Use only a UL listed extension cord recommended for outdoor use. Refer to Extension Cord Chart below. # Don’t handle plug or appliance with wet hands or while standing in water. 1.
OPERATING INSTRUCTIONS VACUUM (Optional on Model 51537 only) A\ caution ¢ Flying debris could cause injury. # Never run vacuum without vacuum bag attached. * Always make sure bag zipper is closed when unit is in use, &\ WARNING * Electric shock can cause injury or death. ® Use only a UL listed extension recommended for outdoor use. See Extension Cord Chart below. +* Don’t handle plug or appliance with wet hands or while standing in water.
MAINTENANCE CLOGGING if the unit should become lagged with debris, the IMPELLER WEAR if a loss of performance is detected while operating blower, unplug unit, remove inlet cover and check impeller blades for wear. If blades are severely worn (Fig. 20), see your Authorized TOR Service Dealer for service and parts. obstruction can usually be cleared by turning the unit off and then promptly compressing the bag while it is still inflated, thereby forcing air back out through the inlet tubes.
The Toto Promise A Two Year Full Residential Use Warranty The Tore Company warrants this TOR Product for two years against defects in material or workmanship. To receive a replacement or repair, at Toto's option, just return the complete unit, postage prepaid, to the seller or any TOR Electric Service Dealer or the TOR Service Center. 5300 Shoreline Blvd., Mound. MN 55364, along with proof of purchase. This warranty covers product defects only. It does not cover incidental or consequential damages.