FORM NO. 01-502-0590 MODEL NO.
FOREWORD Thank you for buying a high quality Toto turf care product. To get the best performance from this making, operate and maintain it according to the instructions in this manual. Toto also wants 10 stress the importance of safety. You and anyone else using or maintaining this machine are strongly urged to read this manual, especially all the safety instructions. DANGER, WARNING and CAUTION, used with the triangular safety alert symbol, highlight safety messages.
TABLE OF CONTENTS Page Page SAFETY INSTRUCTIONS .3-4 LUBRICATION . .. SAFETY AND INSTRUCTION DECALS. . .. 4 STORAGE SPECIFICATIONS . .4 IDENTIFICATION AND ORDERING . OPERATING INSTRUCTIONS .. 6 WARRANTY. SAFETY INSTRUCTION The safety alert symbol means CAUTION, WARNING or DANGER "personal safety instruction”. Read and understand the instruction because it has to do with safety. Failure to comply with the instruction may result in personal injury. BEFORE OPERATING 1.
SAFETY INSTRUCTION {Continued) MAINTENANCE 12. if major repairs are ever needed or assistance desired contact an Authorized TOR Distributor. 11. Remove the key from the tractor’s ignition switch to prevent accidental starting of the engine 13. Make sure machine is in safe operating con when servicing, adjusting or staring the machine. edition by keeping nuts, bolts and screws tight. SAFETY AND INSTRUCTION DECALS The following safety and instruction decals are installed on the unit.
SET UP INSTRUCTIONS ATTACH FRAME TO TRACTOR (Fig. 1) 1. Remove the mower frame from the shipping carton. Remove and unpack any parts that are not already assembled and set aside. 2. Assemble all three bail lit assemblies as follows: A. Attach the bail lift to the housing assembly. Secure with washer and nut. 8. Attach the bail lift assembly 1o the draw bar. Secure with 1/2° x bolts and nuts. 3. Slide both of the forward bail lift assemblies into the pivot tubes on the main frame (Point "A".
OPERATING INSTRUCTIONS BEFORE MOWING Refer to the Toto Operators Manual for Adjusting Bed knife to Reel before mowing is begun. WHILE MOWING 1. The mower is designed to cut grass well at any ground speed between 1 and 6 mph but for most preconditions, ground speeds of 4-8 mph produce the best quality of cut. 2. Always reduce ground speed when turning because excessive speed will cause outside mowers to bounce and skip on the trf.
STORAGE 1. Thoroughly clean the frame of all debris. 2. Check all fasteners for looseness: tighten as necessary. 3. Following the Operators Manual for the reels to clean und sharpen the blades. IDENTIFICATION AND ORDERING MODEL AND SERIAL NUMBER The THREE GANG FRAME 782 has two identification numbers: a mode and serial number. The two numbers are stamped on a plate which is riveted to the extended frame.
The Toto Promise A ONE YEAR LIMITED WARRANTY The Toto Company promises to repair your TOR Product if defective in materials or workmanship. The Hollowing time periods from the date of purchase apply: Commercial Products The costs of parts and labor are included, but the customer pays the transportation costs on walk rotary mowers with cutting widths of less than 25°, If you feel your TOR product is defective and wish to retry on The Toto Promise, the following procedure is recommended: 1.