Installation Instructions

ManualsBrandsToro ManualsTop DressersConveyor and Swivel Kit, ProPass 200 Top Dresser

FormNo.3394-120RevA

ConveyorandSwivelKit

ProPass200TopDresser

ModelNo.44703

InstallationInstructions

Safety

ThisproductcomplieswithallrelevantEuropeandirectives.Fordetails,pleaseseetheDeclarationofIncorporation(DOI)at

thebackofthispublication.

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyareaofpotential

danger.Replaceanydecalthatisdamagedorlost.

119-6838

1.Entanglementhazard,belt—stayawayfrommovingparts,

keepallguardsandshieldsinplace.

119-6843

1.Entanglementhazard,shaft—stayawayfrommovingparts,

keepallguardsandshieldsinplace.

119-6810

1.ReadtheOperator'sManual.

2.Use2peoplerequiredtolift.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3394-120*A

Summary of content (4 pages)

PAGE 1
Form No. 3394-120 Rev A Conveyor and Swivel Kit ProPass 200 Top Dresser Model No. 44703 Installation Instructions Safety This product complies with all relevant European directives. For details, please see the Declaration of Incorporation (DOI) at the back of this publication. Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 119-6838 119-6810 1.
PAGE 2
Installation Note: Before installing the cross conveyor to the top dresser, install the side-rail plates. Using the bolts supplied with the kit, install the left and right side plates (Figure 1). Ensure that the scraper remains in contact with the belt when securing the brackets. 3. Mount the swivel and sliding guard to the swivel assembly with the 7 bolts and nuts. Note: leave the 4 bolts holding the guards together loose. 4. Mount the handle and deflector strap to the conveyor bolts, washers, and nuts.
PAGE 3
Figure 6 The conveyor shown is pinned in the travel position. Figure 4 1. Clamp the swivel to the top dresser 1. Conveyor pinned in the travel position (pin will go through both plates) 7. Check the clearance of the adjustable-belt guard to the top dresser conveyor belt. 9. Connect the hoses as shown in Figure 7.
PAGE 4
Declaration of Incorporation The Toro Company, 8111 Lyndale Ave. South, Bloomington, MN, USA declares that the following unit(s) conform(s) to the directives listed, when installed in accordance with the accompanying instructions onto certain Toro models as indicated on the relevant Declarations of Conformity. Model No. 44703 Serial No.