FORM NO. 01-502-1360.1 OPERATOR’S MANUAL ICON ADAPTER KIT J MODEL NO.
FOREWORD ‘Thank you-for buying a high quality Toto turf care product. To get the best performance from this machine, operate and maintain it according to the instructions in this manual. Toto also wants to stress the importance of safety. You and anyone else using or maintaining this machine are strongly urged to read this manual, specially all the safety instructions. DANGER, WARNING and CAUTION, used with the triangular safety alert symbol, highlight safety messages.
TABLE OF CONTENTS Page SAFETY INSTRUCTIONS 3-4 SAFETY AND INSTRUCTION DECALS 5 SET UP INSTRUCTIONS BEFORE OPERATING OPERATING INSTRUCTIONS 1113 Page MAINTENANCE 13 STORAGE 14 IDENTIFICATION AND ORDERING 14 PROPRIETORSHIP Back Cover SAFETY INSTRUCTIONS The safety alert symbol means CAUTION, WARNING or DANGER “personal safety instruction”. Read and understand the instruction because it has to do with safety. Failure to comply with the Instruction may resit in personal injury. BEFORE OPERATING 1.
SAFETY INSTRUCTIONS (Continued) WHILE OPERATING 10. Operand passenger should remain seated whenever the vehicle is in motion. 11. NEVER fill the hopper with more than 700 Ibs. of material, 12. Using the machine demands attention. Failure to operate vehicle safely may resit in a accident, tip over of vehicle and serious injury or death. Drive carefully. To prevent tipping or loss of control: A.
SAFETY AND INSTRUCTION DECALS The following safety and instruction decals are installed on the unit. Replace any decal that becomes damaged or legible. Part numbers for decals are listed below and in your Parts Catalog. Order replacements from your Authorized Toto Distributor. DANGER SLEDDER CHAIN GUARD & CHAIN Lt GUARD BACK {Part No. 01-506-0050) MAXINE FILL UNE AT 57 BEN STY LR FRONT & REAR OF HOPPER {Loose part, install during assembly) S NO RIDERS: BOTH REAR STABILIZER MOUNTS (Pat No. 75-5190) L.H.
SET UP INSTRUCTIONS IMPORTANT: The Icon Adapter Kit (44240) fits on the Bushman No. 403 Icon Spreader(888401) IMPORTANT: There are several Kits that must be Installed on the Toto Workman before attaching the Icon Spreader. Follow Installation instructions in the Toto Operator's Manual for each of the kits.
SET UP INSTRUCTIONS (Continued) Spacer Guard Bearing WORKMAN Guard Back ‘ £TO Shield Upper J (Storage) Back Knob ? Black Knob g\/\ Spacers Guard Back @ Cover Chain & Master Link Sprocket Rail LH. Chain Guard Rita RH.
SET UP INSTRUCTIONS (Continued) ATTACHING BUSHMAN ICON SPREADER TO WORKMAN(Fig. 2) IMPORTANT:; ALWAYS store the Workman PTO Guard on the Conviction after removal from the Workman. Always replace the Workman Coastguard on the Workman Vehicle when Bushman Icon Spreader Is removed. (See Fig.2) 1. Remove the Full or 2/3rd bed from the Workman. Remove Rear Pto Guard and stirs on Icon Cover. (See Workman and bed operator's manual’s for procedure.) 2.
SET UP INSTRUCTIONS (Continued) ATTACHING HANDLE ASSEMBLY (Flag & 4) 17. Place the Control Handle through the tubing on the Tantamount. Secure with a cotter pin, 16. Attach the Handle Mount to the back of the seat bending to assure lever rotates completely. on the Workman as shown in Fig. 3. Use existing Grip Workman fasteners.
SET UP INSTRUCTIONS (Continued) 18. Attach the Bracket Lever to the Icon Control Rod as shown in Fig. 3. Secure with cotter pin. Attach the other end to the tube on the Icon front tube assembly {Fig. 3 and 4). Control Link ICON Front Tube Assembly 19. Attach the Control Link to the Control Handle and the Bracket Lever. Use 3/8" obits and secure enough to allow the link to pivot. To set the Adjustment Bolt: A, Put the Central Handle back until the Icon metering plate is in the closed position. Bracket B.
BEFORE OPERATING CALCULATE LOAD WEIGHT Ta calculate load weight: 1. Determine density of material to be spread. 2. Determine maximum volume. {Volume =700/ Density) 3. Fill hopper LEVEL FULL up to the matching volume fine on hopper. DO NOT OVERFILL. 4. NEVER filo past 7 cubic foot line with sand. 5. Volumes indicated are with feel material in hopper, NOT heaped. A DANGER NEVER exceed 700 lbs. of material in the hopper. Serous Injury or death could occur from tip overs. Calculate road and use decal.
OPERATING INSTRUCTIONS (Continued) 8. Slowly release clutch pedal and brake pedal. Workman will begin to move and Icon will begin to spread material. 9. Depress the accelerator pedal to desired RPM. 10. Move control handle forward/down to open metering gate and dispense material. Move control handle rearward/up to stop spreading. 11. Place PTO in OFF position when finished spreading. IMPORTANT: Do not engage PTO while moving. Damage will occur to PTO. Always stop vehicle before engaging PTO.
OPERATING INSTRUCTIONS (Continued) if engine stalls or you lose headway on a hill, never attempt to turn vehicle around. Always back straight down a hill in reverse gear. NEVER back down in neutral or with the clutch depressed, using only the brakes. NEVER drive across a steep hill, always drive straight up or down. Avoid turning on shill. the clutch” or slam on the brakes. Sudden speed change can initiate tip over. A CAUTION Using attachments with high inertia (i.e.
SEASONAL STORAGE 1. Thoroughly clean the Icon Spreader and the 2. Tighten all fasteners. Toto Workman. Follow all the guidelines for storage in the respective Operator's Manual. 3. Lubricate all grease fittings and bearings. Wipe off excess lubricant. IDENTIFICATION AND ORDERING To order replacement parts from an authorized 2. Bushman Icon Spreader parts should be Robt Distributor, supply the following information: rained from an authorized Bushman parts supplier. 1.
{Pithy Toto Promise A ONE YEAR LIMITED WARRANTY The Toto Company promises to repair your TOR Product if defective in materials or workmanship. The following time periods from the date of purchase apply: Commercial Products The costs of parts and labor are included, but the customer pays the transportation costs on walk rotary mowers with cutting widths of less than 25", # you feel your TOR product is defective and wish to rely an The Toto Promise, the following procedure is recommended: 1.