MODEL NO. 41570-30101 & UP SET-UPLAND PARTS LIST FOR USE ON THE MULTI-PRO 5200 VEHICLE TOP DRESSER J IDLER SHAFT ADJUSTMENT MOTOR PLATE FRAME RAILS FIG. 1 assembly Place Top Dresser on Vehicle Frame, Inserting the front pins through the holes in the Frame cross member and securing at the rear with two 578 x screws, flat washers and hex nuts. Slide the Spinner Frame Assembly into the rear frame rails as shown in Fi6. 1.
assembly cont. CHAIN TENSION: A Chain that Is too louse will forelimb' on the Sprocket teeth, slap and rua moistly. A chain that is toc tight will cause excessive bearing loads with resulting heat build-up and wear. » HAKE SURE THE SPINNER SHAFT IS STRAIGHT UP AHD DOWN AND TURNS FREELY. tighten bolts securely. ® MAKE SURE THE SPROCKETS ARE [N LINE WITH ONE ANOTHER, Use 2 straight edge to check the Sprocket allotment.
DECALS PART NO. DESCRIPTION Qr 66~1210 "TROD" covariance Passenger Clarence P mesas e 1 Located on the rear of the Hopper. 87-0460 “CAUTION! MAX LOAD LIMIT 3500 2 Located one front and rear of Hopper. 42369 “DANGER! STAY CLEAR WHILE SPINNER IS 1 Located at rear of Hopper, near Spinner 42370 "IMPORTANT: DO NOT REMOVE BUSHINGS, 1 Located at rear of Hopper, near Hyde. Motor. 87-0420 "DANGER! TURN POWER OFF BEFORE 2 Located one front and rear of Hopper.