MODEL NO. 41552-60101 & UP FORM NO. 95-2455 SET-UP AND PARTS LIST “Right” and “Left” as used in the following instructions refer io the operator’s right or left when seated in the operating position. Likewise, “front” and “rear” as seen from the operator's position. 1. Use lacquer thinner to remove the rust preventive coating from the Spreader's input shaft and key way. 2. Loose-assemble the Adjusting Lug to the upright lugs on the Spreader Frame Assembly, using two 5/8 x cap screws, washers and hex nuts.
IMPORTANT: SHAFT ALIGNMENT 1S CRITICAL TO THE OPERATION OF THE SPREADER. FAILURE TO HAVE THE TWO SHAFTS IN ALIGNMENT WITH ONE ANOTHER WILL RESULT IN EXTENSIVE WEAR OR DAMAGE. 10. When alignment has been completed, tighten the Motor Mounting Plate fasteners securely. 11, Install the Universal Joint Cover on the Motor Mounting Plate with four 5/16 x 3/4° cap screws and washers. A Caution ROTATING PARTS CAN CAUSE SERIOUS INJURY. + Keep hands, feet and clothing clear while engine is running.
= Hydraulic Hose from Port " ’ from the Directional Valve / Hydraulic Hose from Port "B from the Directional Valve 87-0450 Located on top of the Universal Joint Cover, SPREADER MOUNTING KIT Ret! Part No. Description Oty Aef | Part No, Description Qty 1 20-121-GAD HHS, 172 {Grade §) 3 12 42845 [Adjustment Lug 2 2 [24-15-AD [Flat Washer, 5/8 U.S.5. 18] 13 20-126-GAD HHS, 5/8 NC x (Grade 5) 4 B [314233 [Square Key, 1/4 x 1-1/4 1 14 [22-15-AJFD R Lock Nut, 42552 End Yoke, 1 15 241380 [Flat Washer, 1/2 SAE.