FORM NO. 93-0644 [ MODEL NO. 41150-40101 MANUAL OPERATOR'S l PA-17 SPREADER J l FOR USE ON THE MULTI-PRO™ 1100 Toastmistress safety, optimum performance, and to ?aln knowledge of the product, it is essential that you or any other operator of this equipment read and understand the contents of this manual before the vehicle engine is ever started.
A\ safety INSTRUCTIONS Keep these Operator’'s Instructions and the Engine Manual in the plastic tube behind the Operator’ seat. It is very important that all persons operating this equipment have easy access to these instructions at all times! Carefully read and follow the "Set-Up® Instructions that are provided with this equipment.
6. DO NOT OVERLOAD THE SPREADER. Maximum load limits are shown on the decapitator not exceed these limit. Failure to position loads carefully can result in their shifting ar tipping over. Distribute loads evenly, keeping them low as possible to prevent the Spreader from becoming top-heavy. 7. Make certain everyone is clear of the machine before starting the engine 1o move the Vehicle or to engage the Spreader drive. 8. Before backing up, look to the rear and assure no one is behind, Back up slowly. 9.
CONTROLS ACCESSORY CONTROL HANDLE is the ON/OFF control for the Spreader, Push the Handle DOWN to engage the Agitator and Spreader Spout mechanisms. Pull the Handle UP toward the operator, to disengage the mechanisms and stop the Agitator and Spreader Spout action. 1. Accessory Control Harley {disengaged) FLOW CONTROL HANDLE: Opens and closes the regulate disc in the Hopper opening, to start or stop the flow of maternal. Pull the Handle forward, toward the operator, o open the regulator disc.
CONTROLS FG, 3 1.8top Pin 2 Calibration Spacer A\ pang Er ROTATING MEMBERS CAN CAUSE SERIOUS INJURY! Before making any adjustments or repairs on the Spreader: ® Stop the Vehicle and set the Parking Brake. ® Shut off the Vehicle's engine and remove the ignition Key. * Pauli the Accessory Control Handle UP to disengage the Spreader drive. SPOUT ARC SETTING: The embossed plus and minus ** signs on the Spreader housing, indicate the operating arc of the Spreader Spout.
CONTROLS SPREADER CALIBRATION To calibrate the TOR Spreader you must determine the desired rate of flow for the material being applied (in pounds per acre}, as specified by the material's manufacturer. To achieve this application rate, first establish the following: 1. The spread width in feet, for the material being applied. NOTE: This width will vary depending on the density of the material-and the Spout arc setting. 2. Flow rate of material from the Hopper, in pounds per acre.
OPERATING INSTRUCTIONS Refer to the charts on page 6 as guidelines to determine the Spout Arcadian Flow Heficl.xalqtor settings to achieve the desired rate of application for the material being used. 1. Position the Stop Pin {and Calibration Spacer if necessary) o stop the Flow Regulator Handle at the desired setting on the Regulator Scale, as described on page 4. 2. Choose the appropriate Spreader Spout and position the Arc Adjuster as needed for the application rate required, as described on page 5, 3.
The Toto Promise A One Year Limited Warranty The Toto Company promises fo repair your Model 41150 PA-17 Spreader and Model 41152 Mounting Kit for the Multi-pro™ 1106 Vehicle if defective in materials or workmanship. The following time periods from the date of purchase apply special warranty terms, on certain components, may be offered through The Toto Company by the component manufacturers: Commercial Products 1 Year The cost of parts, labor and transportation are included.