Form No. 3437-759 Rev D 60V Cordless Power Shovel™ Model No. 39909—Serial No. 320000001 and Up Model No. 39909T—Serial No. 320000001 and Up Register at www.Toro.com.
Important: With your mobile device, you can scan the QR code (if equipped) on the serial number plate to access warranty, parts, and other product information. For assistance, please see www.Toro.com/support for instructional videos or contact 1-888-384-9939 before returning this product. WARNING CALIFORNIA Proposition 65 Warning The power cord on this product contains lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling.
Contents Safety Safety ....................................................................... 3 Safety and Instructional Decals .......................... 6 Setup ........................................................................ 8 Mounting the Battery Charger (Optional)............. 8 Unfolding the Handle .......................................... 9 Installing the Auxiliary Handle ........................... 10 Product Overview ....................................................
9. 10. 11. 12. 13. Do not use the appliance while ill, tired, or under the influence of alcohol or drugs. 1 type of battery pack may create a risk of fire when used with another battery pack. Charge the battery pack in a well-ventilated area only. Do not expose a battery pack or battery charger to fire or to temperatures higher than 68°C (154°F). Follow all charging instructions and do not charge the battery pack outside of the temperature range specified in the instructions.
may affect its operation. Unless indicated in the instructions, have an Authorized Service Dealer repair or replace a damaged guard or part. 6. Keep all fasteners on the appliance tight. 7. Do not attempt to service or repair the appliance, battery pack, or battery charger except as indicated in the instructions. Have an Authorized Service Dealer perform service using identical replacement parts to ensure that the product is safely maintained. 8.
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. Model 39909 decal137-9454 137-9454 1. Read the Operator’s Manual. 2. Call2Recycle® battery recycling program decal140-8455 140-8455 Model 39909T decal140-8456 140-8456 6 3. Keep away from open fire or flames. 4. Do not expose to rain.
decal137-9462 137-9462 decal137-9461 137-9461 1. Battery charge status decal114-9034 114-9034 decal140-8464 140-8464 1. Cutting/dismemberment hazard of foot; auger 3. Read the Operator's Manual. 2. Cutting/dismemberment hazard of hand; impeller 4. Keep bystanders away.
Setup Important: The battery pack is not fully charged when it is purchased. Before using the machine for the first time, refer to Charging the Battery Pack (page 13). Mounting the Battery Charger (Optional) If desired, mount the battery charger securely on a wall using the wall-mount key holes on the back of the charger. Mount it indoors (such as a garage or other dry place), near a power outlet, and out of the reach of children. Refer to Figure 3 for assistance in mounting the charger.
Unfolding the Handle 1. Unfold the handle (A of Figure 4). 2. Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts together (B and C of Figure 4). Note: The locking button clicks into the slotted hole when the shafts are secured (D of Figure 4). 3. Using the provided Allen wrench, tighten the screw on the shaft connector until it is secure (E of Figure 4).
Installing the Auxiliary Handle 1. Separate the auxiliary handle from the handle plate by removing the 4 socket head screws using the provided Allen wrench (A of Figure 5). 2. Line up the auxiliary handle with auxiliary handle plate on the shaft (B of Figure 5). 3. Secure the auxiliary handle to the handle plate with the 4 socket head screws previously removed (C of Figure 5).
Specifications Product Overview Battery Pack Model 88625 2.5 Ah Battery pack capacity 135 Wh Battery manufacturer rating = 60V maximum and 54V nominal. Actual voltage varies with load. Battery Charger Model 88602 Type 60V MAX Lithium-Ion Battery Charger Input 120V AC 50/60Hz Max 2.0A Output 60V MAX DC 2.0A Appropriate Temperature Ranges Figure 6 5. Battery lid 3. Variable-speed switch 6.
Operation Note: If the battery-compartment lid does not close completely, the battery is not fully installed. 6. Starting the Machine To start the machine, squeeze the lockout trigger, then squeeze the run trigger (Figure 10). Important: Use the battery pack only in Note: Slide the variable-speed switch to temperatures that are within the appropriate range; refer to Specifications (page 11). change the speed of the rotor. 1.
Charging the Battery Pack Important: The battery pack is not fully charged when you purchase it. Before using the tool for the first time, place the battery pack in the charger and charge it until the LED display indicates the battery pack is fully charged. Read all safety precautions. Important: Charge the battery pack only in temperatures that are within the appropriate range; refer to Specifications (page 11).
Maintenance Preparing the Battery Pack for Recycling DANGER Important: Upon removal, cover the terminals of the battery pack with heavy-duty adhesive tape. Do not attempt to destroy or disassemble the battery pack or remove any of its components. Contact with the rotor can cause serious personal injury. • Remove the battery pack before adjusting or maintaining the machine.
Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 11). Important: If you are storing the battery pack for the off-season, charge it until 2 or 3 LED indicators turn green on the battery. Do not store a fully charged or fully depleted battery.
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The machine does not run or does not run continuously. 1. The battery is not fully installed in the machine. 1.
Notes:
Notes:
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.