FORM NO. 3316--580 MODEL NO, 3345240001 & UP INSTALLATION INSTRUCTIONS steelmaker@ TRANSPORT FRAME 5 TO 7 UNIT CONVERSION KIT Helping you put quality into play,™ Since this Instruction sheet covers only a minimal amount of Information necessary to maintain and operate your machine, we suggest! that you keep this material with your Operator's Manual so that both may be referred to for Instructions conceding safe operation and proper maintenance procedures. INSTALL HYDRAULIC FITTINGS 1.
MOUNT HYDRAULIC CYLINDERS 1. Mount a cylinder rest to underside of front cross channel with {8) x lg. cap screws, tapered washers and lockouts, as shown in figure 5. 2. Mount butt cap end of hydraulic cylinder to front cross channels with a cylinder shaft, {2) be spacers and (2) 3/16 x ig. cotter pins, as shown in figure 5. 3. Apply #2 spermatozoa threads of new elbow fittings and install fittings to hydraulic cylinder. Position fittings toward center of machine. 4.
Figure § 1. Military 4. Link 2. Frost ores channel & Shalt 3. Lifebelt pins 8. Mount other end of link o hydraulic cylinder with INSTALL LIFT BAIL {2) larger flat washers, flat washers, 3/8 lock washers and x 1" lg. cap screws, as shown in figure 6, garter flat washers to be positioned between link and hydraulic cylinder end, 7. U Transport frame is to be used on a public road, the overall width of frame and mowers may not exceed 8 feet.
2. Insensate bail they holes in it arm and secure with thrust washer and 3/4~ 16 lockout {Fig. 9. A Figure ¢ 1. Lifter 2 Ui bail INSTALL DRAW BAR 1. Align mounting holes in draw bar with mounting hole in lift bail housing. When installing draw bar, offset hole In draw bar should be positioned up and lift bail stop should be on top of draw bar (Fig. 10 & insensate, Figure 10 3. Often holey In drawer-UP 4, Lift bail stop 1. Draw bar 2. Lift bail housing 2. Secure draw bar to iR ball with /213 x 47 ig.
. H Repeal procedures on opposite side of machine. TRANSPORT STRAP STORAGE 1. Place transport strap note pins, located on center frame channel, and secure with {2) hair pin cotters (Fig. 13} Guttural 13 1. Hairpin cotters 2. Transport straps MOUNT CONTROL LINKAGE AND LEVERS 1. Mount valve control lever o valve spool bracket with & link pin and connecting link, as shown in figure 14, Figure 14 1. Yale spoon bracket 3. Control lever 2. Link pin 4. Conn acting ink 2.
Figures 17 1. Poo! valve levers 2. H Mounting pin 10. Thread hex nuts onto lower control rods, Partially thread dower control rods into upper control tubes (Fig. 18). Coat threads with #2 gun grease. Figure 18 1. HS 2. Labor control rad 3. Cotter ping 11. Align hole on end offer control rod (Fig. 18) with amounting pin in control valve lever (Fig. 17). Lever on control tower should be in center of slot {neutral position) if adjusted correctly (Fig. 19).
TRANSPORT OPERATION 1. Make sure that all mowers are in full transport position before moving to the next mowing area, 2. Remove hairpin cotters securing transport straps o center frame channel and §ift off straps (Fig. 13}, 3. Mount transport straps to mounting pins on §ift arms and secure with hale pin cotters {Fig. 20). Figure 20 1.