MODEL NO, & UP MODEL NO. & UP FORM NO. 3310473 OWNER'S MANUAL 24" SNOW THROWER (5 & 7 H.P.) pest COPY AVALANCHES s prey instruction S CAUTION: This Snow thrower is engineered and tested to offer reasonably safe and effective _service, provided it is operated in strict accordance with these instructions. FAILURE TO DO SO MAY-RESULT IN PERSONAL INJURY. TRAINING 1. Never allow children to operate a snow thrower or adults to operate it without proper instruction. 2.
TABLE OF CONTENTS Page General Assembly Instructions Preparation Before Starting Titling With Oil Filling With Gasoline Fuel Shut-Off Know Your Controls Starting . Stopping And Emergency Stopping . Safety interlock System Tips on Snow throwing . Lubrication NN NGO Page Changing Engine Changing Auger Gear Box Ojl .8 Belt Adjustment Traction Dias. Adjustment . .a. -8B Skid Adjustment | . .9 Changing Spark Plug ) Carburetor Adjustment . .
GENERAL ASSEMBLY INSTRUCTIONS {Continued) B Move the dish fink faulty to the deft to insure a full tangs of shifting. Hold the shift rod between the neutral [N} detente and st gear slot on control panel a5 shown. THE ROD MUST 8E HELD AGAINST THE HUMP NOT IN THE NOTCH. {See inset), White holding the'shift fink fully 1o the left, adjust the clevis on the speed selector control rod so the clevis pin slips easily through the thievish and the link.
PREPARATION BEFORE STARTING {Continued) FILLING WITH GASOLINE {Continued) THE CAP MUST BE KEPT IN PLACE ON THE CON. TRAINER EXCEPT WHEN ACTUALLY POURING FUEL. USE A FUNNEL QR A SPOUT WHEN POURING TO PREVENT SPILLING. MANY CHILDREN LIKE THE SMELL OF GASOLINE KEEP 1T QUT OF THEIR REACH-THE FUMES ARE DANGEROUS TO INHALE AS WELL AS BEING EXPLOSIVE. Fill the gas tank with a fresh supply of the new automotive anti-pollution unrivaled regular gasoline or regular gasoline.
OPERATING INSTRUCTIONS WARNING: All hod movements necessary to stop and run this machine should be performed from the Normal Operating Position (behind handles). Thesis a position of maximum safety. I it is necessary to leave this position, shut engine off by polling throttle control lever to the "OFF” position. Place wheel drive lever in Neutral STARTING [IMPORTANT: Check to insure that impeller i not frozen in housing and discharge chute i not obstructed.
OPERATING INSTRUCTIONS (Continued) SAFETY INTERLOCK SYSTEM The safety interlock system is a safety feature which will ground out and stop the engine {through a series of switches) if the operator leaves the operating position without disengaging the auger drive clutch. The hand lever must be depressed 1o keep the engine running when the auger is engaged. This feature also prevents the operator from start ing the engine with the auger drive clutch engaged.
MAINTENANCE {Continued) SKID ADJUSTMENT For normal snow throwing conditions, adjust the skids as | follows: 1. Page wit on feel surface and loosen nuts securing skids to pager side plates. 2. Push forward on the machine so that the pivoting serape blade is pulled to the rear, and position the auger at the desired height, depending on the surface, Insure that skids are parallel with ground and tighten nuts securely.
PRODUCT CHANGES i an effort 1o make improvements available to TOR owners as quickly as possible, minor changes are incorporated into Toto's products from time to time that do not become immediately shown in the Owner’s Manual. If such 2 change apparently has been made in your unit, which is bt reflected in your manual, see your TOR distributor or his Authorized TOR Service Dealer for information.and part numbers, MAINTENANCE RECORD Date Hours Used il Change Lubrication | .