Reference Guide

Revision 1 02-24-2021 Toro Form No 3445-727 Rev A
Tool Inspection Process
Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete
procedures, refer to the Operator’s Manual):
Maintenance Service Interval Maintenance Procedure
After each use
Check for missing or damaged parts, especially safety devices, shields, guards, and decals; ensure that the
machine starts and operates properly.
Tighten all fasteners.
• Check the engine oil level.
• Grease the machine.
Check the air filter cyclone housing for a layer of dirt in the bottom of the container. Clean it if dirty.
• Check the drive belt tension.
• Remove debris from the machine.
Check the condition of the teeth; rotate or replace any that are worn or damaged; torque the nuts for all teeth.
After the first 25 hours Change the engine oil.
Every 50 hours Clean the air filter cyclone housing, air channels, and air intake screen.
Tool Rental Center
Tool Turn Guide
SGR-13 Stump Grinder
Model No. 22615HD316000001 and Up
Supplier Technical Support #:
888-384-9939 (US and Canada)
Supplier Website: www.Toro.com
PURPOSE
Follow the directions below to maintain this tool.
SAFETY
Refer to the product Operator’s Manual for complete safety information.

Summary of content (5 pages)