Form No. 3446-983 Rev A CE Kit STX-26 Stump Grinder Model No. 22368 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal107-8495 107-8495 1. Parking brake © 2021—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN) Printed in the USA.
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 4 5 Description No parts required – Brake bar Locknut Mounting link Flange-head shoulder bolt Idler spring Flange-head nut (8 mm) Flange-head nut (9.
2 3. Loosen the clamp bolts (Figure 1). 4. Push the front road wheel rearward as far as possible (Figure 2). Installing the Parking Brake Parts needed for this procedure: 1 Brake bar 2 Locknut 1 Mounting link 1 Flange-head shoulder bolt 1 Idler spring 2 Flange-head nut (8 mm) 2 Flange-head nut (9.
3. Connect the brake plate to the brake yoke using 3 hex nuts and the threaded rod (Figure 4). g018756 Figure 4 1. Long bolt 2. Flange-head shoulder bolt g019229 8. Hex nut Figure 5 9. Brake plate 3. Locknut 10. Flange-head nut (9.5 mm) 4. Mounting link 11. Locknut 1. Shoulder bolt 2. Hex socket/hex head shoulder bolt 3. Brake plate 5. Flange-head nut (9.5 mm) 12. Brake Yoke 6. Idler spring 13. Hex head shoulder bolt 7. Threaded rod 4. 4. Brake handle 5.
7. Ensure that the track deflects less than 0.6 to 1 cm (1/4 to 3/8 inch) when 20.6 kg (45 lb) of force is applied to the track span. Adjust the torque on the tensioning bolt as needed. 8. Tighten the jam nut. 9. Tighten the clamp bolts and torque to 102 N∙m (75 ft-lb). 10. 5. Tighten the jam nut under the brake plate to secure the setting (Figure 4). 6.
4 5 Installing the Hydraulic Motor Cover Applying the Decals Parts needed for this procedure: Parts needed for this procedure: 1 Hydraulic motor cover 4 Bolt 1 Parking brake decal 1 CE decal Procedure Procedure Place the hydraulic motor cover over the motor and attach to the frame with 4 bolts (Figure 8). 1. Clean the area where the decals will be placed and ensure that it is free of dirt, grease, or other foreign material. 2.
Operation Operating the Parking-Brake Lever To engage the parking brake, lift the lever upward. To disengage the parking brake, push the lever downward. g355524 Figure 10 1.