Form No. 3422-977 Rev C Flex Force Power System™ 60V MAX 22in Recycler® Lawn Mower® Model No. Model No. Model No. Model No. Register at www.Toro.com. Original Instructions (EN) 20363—Serial No. 400000000 and Up 20363T—Serial No. 400000000 and Up 20366—Serial No. 400000000 and Up 20366T—Serial No.
on the product. Write the numbers in the space provided. For assistance, please see www.Toro.com/support for instructional videos or contact 1-888-384-9939 before returning this product. Important: With your mobile device, you can scan the QR code on the serial number decal (if equipped) to access warranty, parts, and other product information.
Safety use an attachment plug adapter of the proper configuration for the power outlet if needed. IMPORTANT SAFETY INSTRUCTIONS 7. Do not use a damaged or modified battery pack or battery charger, which may exhibit unpredictable behavior that results in fire, explosion, or risk of injury. WARNING—When using an electric machine, always read and follow basic safety warnings and instructions to reduce the risk of fire, electric shock, or injury, including the following: 8.
before adjusting, servicing, cleaning, or storing the machine. before adjusting, servicing, cleaning, or storing the machine. 7. Remove the battery pack and electric-start button from the machine whenever you leave it unattended or before changing accessories. 8. Do not force the machine—Allow the machine to do the job better and safer at the rate for which it was designed. 9. Stay alert—Watch what you are doing and use common sense when operating the machine.
disassemble the battery pack. Do not heat the battery pack above 68°C (154°F) or incinerate it. Replace the battery pack with a genuine Toro battery pack only; using another type of battery pack may cause a fire or explosion. Keep battery packs out of the reach of children and in the original packaging until you are ready to use them. 15. Do not dispose of the battery in a fire. The cell may explode. Check with local codes for possible special disposal instructions.
decal131-4514 131-4514 1. Warning—read the Operator's Manual. 2. Cutting/dismemberment hazard of hand, mower blade—stay away from moving parts; keep all guards and shields in place. 3. Cutting/dismemberment hazard of hand, mower blade—disconnect the spark-plug wire before performing maintenance. 4. Thrown object hazard—keep bystanders away; shut off the engine before leaving the operating position; pick up any debris before mowing. decal137-9455 137-9455 Model 88660 5.
decal137-9461 137-9461 1. Battery status decal137-9462 137-9462 decal139-8986 139-8986 decal137-9463 137-9463 1. The battery pack is charging. 3. The battery pack is over or under the appropriate temperature range. 2. The battery pack is fully charged. 4.
Setup Note: The battery pack is not fully charged when it is purchased. Before using the machine for the first time, refer to Charging the Battery Pack (page 17). 1 Mounting the Battery Charger (Optional) No Parts Required Procedure If desired, mount the battery charger securely on a wall using the wall-mount key holes on the back of the charger. Mount it indoors (such as a garage or other dry place), near a power outlet, and out of the reach of children.
2 Unfolding the Handle No Parts Required Procedure WARNING Unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cable(s) when folding or unfolding the handle. • Ensure that the cable(s) are routed to the outside of the handle. • If a cable is damaged, contact an Authorized Service Dealer. Important: Remove and discard the protective plastic sheet that covers the motor and any other plastic or wrapping on the machine. 1.
3 Assembling the Grass Bag No Parts Required Procedure g230447 Figure 4 10
Product Overview g274555 Figure 7 1. Battery charger (included with Model 20363 and 20366) 3. Battery pack model 88660 (included with Model 20363) 2. Battery pack model 88675 (included with Model 20366) Specifications Appropriate Temperature Ranges g284083 Charge/store the battery pack at 5°C (41°F) to 40°C (104°F)* Use the battery pack at -30°C (-22°F) to 49°C (120°F)* Use the machine at 0°C (32°F) to 49°C (120°F)* Store the machine at 0°C (32°F) to 49°C (120°F)* Figure 5 1.
Operation Before Operation Installing the Battery Pack Important: Operate the battery pack only in temperatures that are within the appropriate range; refer to Specifications (page 11). 1. Make sure that the vents on the battery are clear of any dust and debris. 2. Lift up the battery-compartment lid (A of Figure 8). 3. Line up the cavity in the battery pack with the tongue on the machine and slide the battery pack into the compartment until it locks into place (B of Figure 8). 4.
Adjusting the Cutting Height Adjust the cutting height as desired. Set all wheels to the same cutting height (Figure 9). g254131 Figure 9 During Operation Starting the Machine 1. Ensure that the battery pack is installed in the machine; refer to Installing the Battery Pack (page 12). 2. Insert the electric-start button into the electric starter (A of Figure 10). 3. Press the electric-start button and keep it pressed (B of Figure 10). 4.
Using the Self-Propel Drive Simply walk with your hands on the upper handle and your elbows at your sides, and the machine will automatically keep pace with you (Figure 11). g233423 Figure 11 Note: If the machine does not freely roll backward after self-propelling, stop walking, hold your hands in place, and allow the machine to roll a couple of centimeters (inches) forward to disengage the wheel drive.
Removing the Grass Bag To remove the bag, reverse the steps in Installing the Grass Bag (page 14). Operating the Bag-on-Demand Lever • To recycle or side-discharge the grass and leaf clippings, press the button on the lever and move the lever rearward until the button on the lever pops up. The bag-on-demand feature allows you to either collect or recycle grass and leaf clippings while the grass bag is attached to the machine.
Operating Tips Shutting Off the Machine 1. Release the blade-control bar (A of Figure 16). 2. Remove the electric-start button from the electric starter (B of Figure 16). 3. General Mowing Tips • Avoid striking solid objects with the blade. Never deliberately mow over any object. Remove the battery pack; refer to Removing the Battery Pack from the Machine (page 16). • For best performance, install a new blade before the cutting season begins.
After Operation Charging the Battery Pack Important: The battery pack is not fully charged when you purchase it. Before using the machine for the first time, place the battery pack in the charger and charge it until the LED display indicates the battery pack is fully charged. Read all safety precautions. Important: Charge the battery pack only in temperatures that are within the appropriate range; refer to Specifications (page 11).
3. Lower the machine to its lowest cutting-height setting. Refer to Adjusting the Cutting Height (page 13). 4. Wash out the area under the rear door where the clippings go from the underside of the machine to the grass bag. Folding the Handle WARNING Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. Note: Wash out the area with the bag-on-demand (if equipped) in both the fully forward and fully rearward positions. 5.
g251585 Figure 22 4. Fold the handle fully forward. Important: Route the cables to the outside of the handle knobs as you fold the handle. 5. Engage the handle locks. 6. Lift the front of the machine by the handle and move it into a storage space (Figure 23). g251299 Figure 21 5. To unfold the handle, refer to 2 Unfolding the Handle (page 9).
Maintenance Remove the electric-start button and battery pack from the machine before maintaining or cleaning the machine. Use only the manufacturer’s recommended replacement parts and accessories. Inspect and maintain the machine regularly. Have the machine repaired only by an Authorized Service Dealer. Lubricating the Machine g231389 You do not need to lubricate the machine; all the bearings have been lubricated at the factory for the life of the machine. Figure 24 4.
Adjusting the Self-Propel Drive Preparing the Battery Pack for Recycling For Self-Propel-Drive Models Only Important: Upon removal, cover the terminals of the battery pack with heavy-duty adhesive tape. Do not attempt to destroy or disassemble the battery pack or remove any of its components. Whenever you install a new self-propel cable or if the self-propel drive is out of adjustment, adjust the self-propel drive. 1.
Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 11). Important: If you are storing the machine for a year or longer, remove the battery pack from the machine and charge the battery pack until 2 or 3 LED indicators turn blue on the battery. Do not store a fully charged or fully depleted battery.
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem The machine does not start. Possible Cause Corrective Action 1. The battery is not fully installed in the machine. 1. Remove and then replace the battery into the machine, making sure that it is fully installed and latched. 2.
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
