Operator's Manual

ManualsBrandsToro ManualsLawn Mower20067

Form No. 3358-405 Rev A

22in Recycler® Lawn Mower

Model No. 20066 —Serial No. 270000001 and Up

Model No. 20067 —Serial No. 270000001 and Up

Operator's Manual

Introduction

R ead this infor mation carefully to lear n ho w to operate and

maintain y our product properly and to a v oid injur y and

product damag e . Y ou are responsible for operating the

product properly and safely .

Y ou ma y contact T oro directly at www .T oro .com for

product and accessor y infor mation, help ﬁnding a dealer ,

or to register y our product.

W henev er y ou need ser vice , g en uine T oro par ts , or

additional infor mation, contact an A uthorized Ser vice

Dealer or T oro Customer Ser vice and ha v e the model and

serial n umbers of y our product ready . Figure 1 identiﬁes the

location of the model and serial n umbers on the product.

Figure 1

1. Model and serial number plate

W rite the product model and serial n umbers in the space

belo w:

Model No.

Serial No.

T his man ual identiﬁes potential hazards and has safety

messag es identiﬁed b y the safety aler t symbol ( Figure 2 ),

whic h signals a hazard that ma y cause serious injur y or

death if y ou do not follo w the recommended precautions .

Figure 2

1. Safety alert symbol

T his man ual uses 2 w ords to highlight infor mation.

Impor tant calls attention to special mec hanical infor mation

and Note emphasizes g eneral infor mation w or th y of special

attention.

Warning

CALIFORNIA

Pr oposition 65 W ar ning

T he engine exhaust fr om this pr oduct contains

chemicals kno wn to the State of Calif or nia to cause

cancer , bir th defects, or other r epr oducti v e har m.

Important: T his engine is not equipped with a

spar k ar r ester muf ﬂer . It is a violation of Calif or nia

Public R esource Code Section 4442 to use or operate

the engine on an y f or est-co v er ed, br ush-co v er ed, or

g rass-co v er ed land. Other states or federal ar eas may

ha v e similar la ws.

T his spark ignition system complies with Canadian

ICES-002

T he enclosed Engine Owner’ s Man ual is supplied

f or inf or mation r egarding the US En vir onmental

Pr otection Agency (EP A) and the Calif or nia Emission

Contr ol R egulation of emission systems, maintenance,

and w ar ranty . R eplacements may be order ed thr ough

the engine man uf actur er .

F or models with stated engine horse po w er , the g ross

horse po w er of the engine w as laborator y rated b y the engine

man ufacturer in accordance with SAE J1940. As conﬁgured

to meet safety , emission, and operating requirements , the

actual engine horse po w er on this class of la wn mo w er will

be signiﬁcantly lo w er .

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA

Summary of content (20 pages)

PAGE 1
Form No. 3358-405 Rev A 22in Recycler® Lawn Mower Model No. 20066—Serial No. 270000001 and Up Model No. 20067—Serial No. 270000001 and Up Operator's Manual Introduction Read this information carefully to learn how to operate and maintain your product properly and to avoid injury and product damage. You are responsible for operating the product properly and safely. You may contact Toro directly at www.Toro.com for product and accessory information, help ﬁnding a dealer, or to register your product.
PAGE 2
Safety • Do not operate machine while under the inﬂuence of This lawn mower meets or exceeds the CPSC blade safety requirements for walk-behind rotary lawn mowers and the B71.1 speciﬁcations of the American National Standards Institute in effect at the time of production. • Read and understand the contents of this manual before you start the engine. • The safety alert symbol (Figure 2) is used to alert you to potential personal injury hazards.
PAGE 3
• Extinguish all cigarettes, cigars, pipes, and other sources • Mower blades are sharp. Wrap the blade or wear gloves, of ignition. and use extra caution when servicing them. • Use only an approved gasoline container. • Never remove gas cap or add fuel with the engine • Do not change the engine governor setting or overspeed the engine. running. Allow engine to cool before refueling. • Maintain or replace safety and instruction labels, as necessary. • Never refuel the machine indoors.
PAGE 4
104-7403 Model 20067 only 112-8868 4
PAGE 5
104-7953 Model 20067 only 1. 2. Warning—read the Operator’s Manual for information on charging the battery; contains lead; do not discard. Read the Operator’s Manual.
PAGE 6
Setup Important: Remove and discard the protective plastic sheet that covers the engine. 1. Unfolding the Handle Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. Figure 5 2. Filling the Engine with Oil • Do not damage the cables when folding or Your mower does not come with oil in the engine, but it does come with a bottle of oil. unfolding the handle. • If a cable is damaged, contact an Authorized 1. Remove the dipstick (Figure 6).
PAGE 7
Product Overview Figure 7 2. Insert the fuse into the fuse holder (Figure 8). Figure 8 Note: Your mower comes with a fuse in the owner’s packet and another fuse in the battery box. 3. Install the battery cover. 4. Charging the Battery Model 20067 only Refer to Charging the Battery in the Maintenance section. Figure 9 1. Cutting height lever 2. 3. 4. 5. 6. Air lter Fuel tank cap Recoil start handle Blade control bar Handle 7. Ignition key (model 20067 only) 8. Oil ll/dipstick 9.
PAGE 8
Operation Checking the Engine Oil Level 1. Remove the dipstick, wipe it clean, and fully install the dipstick (Figure 12). Filling the Fuel Tank Gasoline is extremely ﬂammable and explosive. A ﬁre or explosion from gasoline can burn you and others. • To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before ﬁlling, not in a vehicle or on an object. Figure 12 2. Remove the dipstick and check the oil level (Figure 12).
PAGE 9
Adjusting the Cutting Height Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury. • Stop the engine and wait for all moving parts to stop. • Do not put your ﬁngers under the housing when adjusting the cutting height. If the engine has been running, the mufﬂer will be hot and can severely burn you. Keep away from the hot mufﬂer. Adjust the cutting height as desired. Set the front wheels to the same height as the rear wheels (Figure 13).
PAGE 10
Starting the Engine 1. Firmly push in the primer 3 times with your thumb, holding the primer in for a second before releasing it each time (Figure 14). Figure 16 Figure 14 Note: If the air temperature is below 55°F (13°C), ﬁrmly push the primer in 5 times. 2. Hold the blade control bar against the handle (Figure 15). Figure 17 4. If the mower does not start in 1 or 2 pulls (or within 5 seconds using the electric starter), press the primer button 1 or 2 times and try starting it again.
PAGE 11
Using the Self-propel Drive Bagging the Clippings To operate the self-propel drive, simply walk with your hands on the upper handle and your elbows at your sides, and the mower will automatically keep pace with you (Figure 18). Use the grass bag when you want to collect grass and leaf clippings from the lawn.
PAGE 12
Side-discharging the Clippings Use the side discharge for cutting very tall grass. If the bag is on the mower, remove it before side-discharging the clippings. The blade is sharp; contacting the blade can result in serious personal injury. Stop the engine and wait for all moving parts to stop before leaving the operating position. Installing the Side Discharge Chute 1. Unlock the side discharge door (Figure 21). Figure 21 2. Install the side discharge chute (Figure 22). Figure 20 3.
PAGE 13
Figure 23 Operating Tips General Mowing Tips • Clear the area of sticks, stones, wire, branches, and other debris that the blade could hit. • Avoid striking solid objects with the blade. Never deliberately mow over any object. • If the mower strikes an object or starts to vibrate, immediately stop the engine, disconnect the wire from the spark plug, and examine the mower for damage. • For best performance, install a new blade before the cutting season begins.
PAGE 14
• Alternate the mowing direction. This helps disperse the • the front wheels at 2 inches (51 mm) and the rear wheels at 2-3/8 inches (60 mm). clippings over the lawn for even fertilization. If the ﬁnished lawn appearance is unsatisfactory, try one or more of the following: – Replace the blade or have it sharpened. – Walk at a slower pace while mowing. – Raise the cutting height on your mower. – Cut the grass more frequently. – Overlap cutting swaths instead of cutting a full swath with each pass.
PAGE 15
Preparing for Maintenance 1. Stop the engine and wait for all moving parts to stop. 2. Disconnect the spark plug wire from the spark plug and hook it onto the retaining post (Figure 24) before performing any maintenance procedure. Figure 26 3. Install the cover. Changing the Engine Oil Figure 24 Change the engine oil after the ﬁrst 5 operating hours; change it yearly thereafter. 3. After performing the maintenance procedure(s), connect the spark plug wire to the spark plug.
PAGE 16
Lubricating the Wheel Gears 1. Remove the wheel bolts on the rear wheels and remove the rear wheels. 2. Apply a lubricating oil to the inner and outer sides of the gear as shown in Figure 31. Figure 29 5. Install the dipstick securely. 6. Dispose of the used oil properly at a local recycling center. Charging the Battery Model 20067 only Warning Figure 31 CALIFORNIA Proposition 65 Warning 3. Install the rear wheels.
PAGE 17
Adjusting the Self-propel Drive Cable Whenever you install a new self-propel cable or if the self-propel drive is out of adjustment, adjust the self-propel drive cable. 1. Loosen the cable support nut (Figure 34). Figure 32 4. Remove the blade, saving all mounting hardware (Figure 32). 5. Install the new blade and all mounting hardware (Figure 33). Figure 34 2. Pull down the cable jacket (toward the mower) until there is no slack in the cable (Figure 35). Figure 35 3.
PAGE 18
Storage Cleaning the Mower Store the mower in a cool, clean, dry place. The mower may dislodge material from under the mower housing. Preparing the Mower for Storage • Wear eye protection. • Stay in the operating position (behind the handle) when the engine is running. • Do not allow bystanders in the area. Gasoline vapors can explode. • Do not store gasoline more than 30 days. For best results, clean the mower soon after you have completed mowing.
PAGE 19
Folding the Handle Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. 1. Remove the ignition key (model 20067 only). 2. Loosen the handle knobs until you can move the upper handle freely. 3. Fold the upper handle forward as shown in Figure 37.
PAGE 20
The Toro Total Coverage Guarantee A Two -Year Full Warranty (Limited for Commercial Use) and The Toro Starting Guarantee on GTS-2 (Guaranteed to Start) Engines A Two -Year Full Warranty (Not applicable for Commercial Use) 22in Recycler® Walk Power Mowers Conditions and Products Covered under The Toro Total Coverage Guarantee The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly promise to repair any Toro Product, when used for residential purposes*, if d