Installation Instructions

FormNo.3444-558RevA

Dingo

ReectorKit

CompactToolCarrier

ModelNo.144-7107

InstallationInstructions

InstallingtheReector

PreparingtheMachine

1.Parkthemachineonalevelsurfaceinawarm

area.

2.Lowertheattachments.

3.Engagetheparkingbrake.

4.Shutofftheengineandremovethekey.

5.Waitforallmovingpartstostop.

6.Ifthemachineiscold,allowthesteelsurfaces

atthebackofthemachine(Figure1andFigure

2)towarm.

g345324

Figure1

TX427andTX525Machines

g345322

Figure2

TX1000Machines

InstallingtheDecal

TX427andTX525Machines

1.Usealcoholandacleanragtowipecleanthe

mountingsurfaceoftherear-supportcover

whereyouwillapplythereectordecal(Figure

3).

g345324

g345323

Figure3

1.Rearaccesscover

4.10mm(3/8inch)

2.Rear-supportcover

5.3mm(1/8inch)—outboard

ofrearaccesscover

3.Reectordecal

8111LyndaleAvenueSouth

Bloomington,MN55420Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3444-558*

PAGE 1
Form No. 3444-558 Rev A Dingo® Reflector Kit Compact Tool Carrier Model No. 144-7107 Installation Instructions Installing the Reflector Installing the Decal TX427 and TX525 Machines Preparing the Machine 1. 1. Park the machine on a level surface in a warm area. 2. Lower the attachments. 3. Engage the parking brake. 4. Shut off the engine and remove the key. 5. Wait for all moving parts to stop. 6.
PAGE 2
. 3. 4. 5. Ensure that the decal mount surface of the support cover is dry. Remove the backing from the reflector decal. Adhere the decal to the rear-support cover as shown in Figure 3. Repeat steps 1 through 4 at the other rear-support cover. 5. Installing the Decal TX1000 Machines 1. Use alcohol and a clean rag to wipe clean the mounting surface of the tank plate where you will apply the reflector decal (Figure 4). g345322 g345321 Figure 4 1. 13 mm (1/2 inch)—inboard 3.