Installation Instructions

ManualsBrandsToro ManualsGreens RollerTraction Link Kit, GreensPro 1260 Greens Roller

FormNo.3448-567RevA

TractionLinkKit

GreensPro

1260GreensRoller

ModelNo.144-3595

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Link1

Bellcrank1

Shoulderbolt

Spacer

Flatwasher(5/16inch)

Spacer(1/4inch)

Bolt(1/4x2inches)

Locknut(1/4inch)

Pivotbushing1

Washer(3/8inch)

Bolt(M10x70)

Locknut(M10)

Washer(M10)

Installthelink.

PreparingtheMachine

1.Parkthemachineonalevelsurface,movethe

motionpedalstotheNEUTRALposition,move

thethrottlelevertotheIDLEposition;referto

yourmachineOperator’sManual.

2.DisengagethePTO,engagetheparkingbrake,

shutofftheengine,andwaitforallmovingparts

tostopbeforeleavingtheoperator’sseat.

3.Iftheengineishot,waitfortheengineand

hydraulicsystemtocool.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3448-567*

Summary of content (4 pages)

PAGE 1
Form No. 3448-567 Rev A Traction Link Kit GreensPro® 1260 Greens Roller Model No. 144-3595 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine.
PAGE 2
Installing the Link 1. Tilt the seat forward. g370725 Figure 2 1. Hydraulic-oil tank g279773 Figure 1 1. Seat latch 2. 2. Seat-latch pin Remove the hydraulic-oil tank from the cover under the seat (Figure 2). Note: Do not remove any hydraulic hoses. 3. Remove the cover under the seat (Figure 2). 2 2. Cover 4. To gain access under the machine, raise the machine and support it with jack stands. 5. Remove the cable clamp from the existing cable and discard (Figure 3).
PAGE 3
g370723 Figure 3 1. Existing clamp g370722 6. Figure 4 Remove the existing cable from the existing bellcrank and hydraulic pump (Figure 4). Retain the hardware for the right side of the bellcrank. 1. Cable 3 2.
PAGE 4
7. Install the new bellcrank to the machine with a bolt (M10 x 70), washer (M10), pivot bushing, washer (3/8 inch), and a locknut (M10); refer to (Figure 5). 8. Install the right side of the bellcrank to the right-side pedal connection using the previously removed hardware. 9. Slide the new link into the hole near the hydraulic pump (Figure 5). 10. Install the new link to the new bellcrank with a bolt (1/4 x 2 inches), spacer (1/4 inch), existing rod end, and locknut (1/4 inch); refer to (Figure 5).